Issue link: http://read.dmtmag.com/i/814629
1 800 255 4417 www.castrol.com/GPS March 2017 Reference Materials Technical Reference Information Metalworking Technical Metalworking Fluid Troubleshooting Potential Cause Problem Low Concentration High Concentration High Tramp Oil High Dirt/Fines Low Hardness (Soft Water) High Hardness Low pH High pH (cleaner contam.) Mechanically induced / Low fluid level High Chlorides Stagnant Fluid Metals Contam(Zn,Cr,Ni,Co) Personal Hygiene Lack of PPE Poor Coolant Flow Flow not directed to point- of-cut Poor Tool Regrind Low or high fluid temp Foam X X X X X X Residues X X X X Rust X X X X X Dermal Irritation X X X X X X X Chemical Odor X X Rancid Odor (bacteria) X X X X X Musty Odor (fungus) X X X X X Poor Tool Life X X X X X X X Poor Machining X X X X X X X Foam and air entrainment can occur due to mechanical problems or chemical problems. A simple shake test can help determine which type of problem exists: 1. Fill a clear sample bottle half full with the fluid. 2. Vigorously shake the sample for 15 seconds. 3. If the foam breaks quickly (<30 sec), the coolant is performing as expected and mechanical problems exist. 4. If the foam persists, a chemical problem with the coolant is occurring. Mechanical problems may include: • Low sump volume or short residence time • High agitation/splashing • Excessive fluid velocities • Damaged system components (i.e. cavitating pump, loose fittings, cracks, etc.) • Partially clogged coolant nozzles • Unnecessary flush lines and waterfalls Chemical problems may include: • High concentration • Excessive tramp oil • Soft water • Improper fluid temperature • Contamination by another chemical 2

