Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 104 of 385

1 800 255 4417 www.castrol.com/GPS March 2017 Reference Materials Technical Reference Information Metalworking Technical Coolant Changeover Procedure The basic steps for cleaning out an individual machine sump are as follows: 1. Pump out the old coolant and physically remove all chips, sludge, and fungal masses present. Make any needed repairs to sump, filters, piping, nozzles, etc. 2. Charge the system to pumping capacity with a heavy duty alkaline machine cleaner (such as Castrol Techniclean MP Flex) at recommended concentration (typically 3%). 3. Circulate cleaner solution for 2-4 hours* in order to loosen dirt, debris and excess build up. 4. Pump out the cleaner fluid and physically remove any remaining fluid, sludge, and dirt. 5. Charge the system to pumping capacity with a rinse solution using water and low concentration of the new coolant (typically 2-3% to prevent flash rust). 6. Rinse the system until all cleaner residue is collected. 7. Pump out the rinse solution thoroughly. 8. Fill the system 1/3 to 1/2 full with water and add the full amount of coolant concentrate needed to achieve target concentration at full capacity. 9. Additions of coolant concentrate should always be made at a point of agitation and, if possible, the system should be set to cycle the fluid continuously. 10. Continue to fill the system with water until the system is at full volume. 11. Confirm target concentration has been met and adjust as needed. Note: The cleaner stage is important to ensure all old fluid, sludge, and residues are removed. The rinse step is equally important to remove the cleaner, so it does not contaminate and reduce the effectiveness of the new coolant. *Circulation time is dependent on system size and degree of dirtiness. More than 4 hours may be needed. Determining Sump Volume: Measure the length (L) and width (W) of the tank along with the normal height (H) of the coolant in inches. Sump Volume (gallons) = L x W x H/231 Example: Length of the sump is 60 inches, width is 40 inches, and the coolant height is 18 inches Sump Volume = 60 x 40 x 18/231 = 187 gallons 4

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES