Issue link: http://read.dmtmag.com/i/814629
1 800 255 4417 www.castrol.com/GPS March 2017 Industrial Lubricants Product Data Gear Oils Types of Gears Spur Gears A spur gear is a toothed wheel whose teeth run parallel to the gear shaft or axle. Spur gears are simple to manufacture, limited in their load carrying ability and known for their noisy operation. Helical Gears Similar in design to the spur gear, the teeth of the helical gear are angled or twisted to allow several teeth to mesh at the same time. Because the gear teeth engagement area is larger, helical gears carry greater loads and run more quietly and smoothly than spur gears do. Herringbone Gears A double helical gear is commonly called a herringbone gear, based on the opposing angles of the gear teeth. Herringbone gears can carry heavy loads at high speed and, in contrast to helical gears, have a balanced load to prevent thrust. Bevel Gears Bevel gears employ two intersecting shafts with meshing teeth cut straight across the face of the cone-shaped gear blank. Bevel gears are commonly used when a 90° change in direction of shaft power is required. A special grouping of bevel gears is used in automotive differentials to divide power between two variable speed shafts. Spiral Bevel Gears The teeth of an ordinary bevel gear can be twisted to form a spiral bevel gear. The "spiral" look results from cutting angled teeth into a cone-shaped gear. The angled teeth allow for a quiet, smooth trans- fer of power and strong gear system. Worm Gears Worm gears utilize a screw-like gear as the pinion that drives a larger wheel gear, with perpendicular non-intersecting shaft locations. Due to the heavy sliding nature of the worm gear, lubricants employing special additives are necessary. Worm gears are typically found where great velocity reductions and/or high torque increases are required in a small gearbox arrangement. Hypoid Gears A modification of the spiral bevel gear, hypoid gears transmit motion between perpendicular, non-intersecting shafts. Hypoid gears have inherently strong teeth, excellent load-carrying ability and near-noiseless operation. The high sliding motion of the hypoid gear requires lubricants with special additives to maintain film strength. These gear sets are commonly found in automotive differentials. G 2

