Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 142 of 385

1 800 255 4417 www.castrol.com/GPS March 2017 Industrial Lubricants Product Data Multi-Purpose, High-Performance Greases Improving Lubrication through Plastic Deformation Castrol utilizes two proprietary additive systems – TGOA (Tribol Gear Oil Additive) and MFT (Microflux TRANS - TRiple Action Non-sacrificial Surface engineering) – to improve friction surfaces to an extent not possible with normal machining processes and conventional EP or anti-scuff lubricants. These additives create an instantaneous passive film on metal surfaces before friction occurs. Under severe load, components of the additive combination are activated and diffuse into the metal surfaces, initiating an improvement of their frictional characteristics through plastic deformation. This unique physio-chemical reaction achieves a non-sacrificial micro-smoothing of the friction surfaces that provides optimum wear protection and an extremely low coefficient of friction even under extremes of pressure, vibration, shock loads and varying speeds. Solid lubricants are worked onto the metal surface to help prevent metal-to-metal contact Lubricating solids have a natural affinity for metal surfaces and provide an additional layer of protection to lower frictional forces and reduce wear rates. The MoS2 structure of Molybdenum Disulfide allows for extremely high load carrying capability in the perpendicular direction (250,000 psi) while shearing easily in the parallel direction to provide very low coefficient of friction to moving parts. Sulfide layers shear easily in this direction to produce low coefficient of friction Mo Mo Mo Mo Mo S S S S S S S S Mo Mo Mo Mo Mo S S S S S S S S Extremely high load carrying capacity in this direction (250,000 psi) Layer of Solid film Additives These technologies are found in the following Castrol greases: Tribol GR 100 PD, Tribol GR 400-3 PD, Tribol GR 1350-2.5 PD, Tribol GR 3020/1000 PD and Tribol 4020 PD. Step 1: TGOA and MFT additive begins to build onto the naturally rough metal surface. Step 2: Under load, the additives compress to create a tough protective layer, allowing metal smoothing to begin. Step 3: At continuously increasing loads, the additives diffuse into the structure of the metal surface, thus initiating the micro-smoothening effect. This leads to a contact area up to four times higher, and subsequently results in greatly reduced friction. The process of plastic deformation created through the proprietary Castrol additive systems TGOA and MFT, leading to improvement of metal surfaces not possible through other means. I 4

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES