Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 221 of 385

Technical Reference Information Lubrication Technical 1 800 255 4417 www.castrol.com/GPS March 2017 Reference Materials General Oil Changeover Procedure This is a generic procedure for hydraulics, gears, compressors, etc. Since each lubrication system is unique, a specific procedure should be developed for your situation.* 1. For systems with build-up of varnish, carbonaceous residues or sludge, Castrol TECHNICLEAN SC 320 detergent cleaner should be used to remove the contaminants. Add the cleaner to the current oil a minimum of 48-72 hours prior to conversion. Use a concentration of 1-5% depending on the level of contamination. The cleaner will dissolve the contaminants and keep them in suspension until the change-out. Monitor sensitive components and filters during this time as they may load up much faster than normal. For more specific guidelines on the use of TECHNICLEAN SC 320, please contact your Castrol representative. For systems with minimal contamination, skip this step and follow the procedure below. 2. Ensure that the oil has been running at normal operating temperatures prior to shutdown. 3. Drain as much of the warm fluid as possible from all areas of the system. 4. Physically remove all residual fluid and sludge from the reservoir and other areas of the lubrication system. Physically clean all areas of the system that are accessible. 5. Change filters, removing excess fluid from filter housings. 6. For the following situations, the flushing procedure in #8 should be completed: a. Castrol TECHNICLEAN SC 320 was added prior to the change b. A significant volume of the old fluid cannot be drained or sucked from the system c. The new oil is of a different type or incompatible with the old fluid d. The system has a high level of contamination 7. Flushing procedure: a. Fill reservoir with the appropriate amount of flushing fluid. In most cases, this will be the same oil that you are converting to. b. Start the unit and run loaded or unloaded with the flushing fluid to reach an elevated oil temperature. Higher temperatures will facilitate better flushing. Circulate the flushing oil at the elevated temperature for a minimum of 2 hours. c. Drain as much of the warm flushing fluid as possible from all areas of the system. d. Physically remove all residual fluid from the reservoir and other areas of the lubrication system. e. Change filters, removing excess fluid from filter housings. f. Repeat flushing procedure if necessary to remove all old fluid and contaminants. 8. Fill system to normal operating level with new fluid. 9. Take a sample once the system has circulated at operating temperature for at least 24 hours. This will verify how well the system flush was performed and will serve as the baseline for future samples. *Note: When converting to a different type of fluid, ensure the system seals and components are compatible and make any system modifications as necessary prior to or during conversion. Use good contamination control techniques during conversion to minimize dirt in the new fluid. 5

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES