Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Metalworking Technical Training Cutting and Grinding 1 800 255 4417 www.castrol.com/GPS March 2017 Figure 2. The effect of lubrication on surface finish. Coolant A clearly provided much better lubrication than Coolant B. Coolant A Coolant B Functions of Metalworking Fluids As we try to alter the shape of one material (the work- piece) with the use of another material (the tool) in a dry state, friction and heat work against us. The workpiece resists being cut, temperature builds up and the process becomes very inefficient. An important discovery in metalworking, therefore, was the recognition of the value of using fluids during the cutting process. It began with the use of water to wet grinding stones and has progressed to the sophisticated coolant technologies that we employ today. In its most basic role, a metalworking fluid (MWF) is used to make the process of removing or shaping metal more efficient and to provide a better-quality finished product. Cooling and lubrication are the two most important functions provided by the metal removal fluid at the point of cut, but many secondary functions are required as well. Below are the key characteristics of metalworking fluids and the value that they can provide. Cooling Most of the energy expended in metal cutting operations is converted to heat. Left uncontrolled, this would render the cutting process impractical due to loss of cutting tool hardness and poor size control of the workpiece. MWFs are used to cool the workpiece and the cutting edge of the tool. This prevents excessive wear on the tool and metal pieces from building heat. Cooling provides a more consistent wear on the cutting tool and improves the surface finish. Water-based fluids provide better cooling than neat cutting oils do. Figure 1. Heat distribution in a cutting operation. Ideally the coolant and chip absorb most of the heat, keeping it away from the workpiece and tool. Heat Distribution Chip Tool Workpiece High Temperature Zone 15% 70% 15% Machined Surface Lubrication In metal cutting, friction is prominent, which in turn produces heat. The lubricating properties of the MWF reduce the force needed to cut efficiently by lowering the total friction. This helps to improve surface finish, improve tool life, reduce the amount of energy the ma- chine needs to operate and assist in size consistency. Without sufficient lubrication, tool/workpiece interfaces can reach temperatures that are high enough for micro- welding to occur. Evidence of micro-welding is found in galled and smeared metal and pitted tool surfaces. Q2

