Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 249 of 385

Technical Training and Reference Info Metalworking Technical Training Cutting and Grinding 1 800 255 4417 www.castrol.com/GPS March 2017 Workpiece Metallurgy Stainless Steel Stainless steel is a special group of alloy steel. It contains at least 10.5% chromium, typically with other alloying agents such as nickel, molybdenum and manganese. As the name implies, it has excellent corrosion resistance as compared to carbon steel. Stainless steel is tough and gummy, and work hardens quickly during machining. It comes in many grades, with SAE 300 series and 400 series being the most common in industry. Newer types are called duplex and triplex stainless steel, which combine austenitic (200 and 300 series) and ferritic (400 series) grades, making them harder than typical stainless steel. Fast cooling rates are essential in cutting applications of the stainless steel alloys. Typically, high performance synthetic coolants and medium to high oil semi-synthetics are used. Titanium Titanium and its alloys have high strength like steel, but are 45% lighter. They are very difficult to machine and are found commonly in aerospace, medical and marine industries. Due to titanium's low thermal conductivity, heat from the cutting process is absorbed almost exclusively by the chip and tool (and, hopefully, the coolant). Titanium has a tendency to weld to the cutting tool under pressure and its abrasive oxides create wear on cutting tools. Low cutting speeds and high feed rates are used to overcome these challenges. High-pressure coolant with good flow to the point-of-cut is essential for fast heat removal from the tool. High performance synthetic coolants are best in order to provide excellent cooling and lubrication. High- performance semi-synthetic coolants and EP neat oils are often used as well. High Temperature/Nickel Alloys High temperature, heat-resistant nickel-based materials are commonly used in applications with high heat/high stress and in highly corrosive environments where steel would fail. These materials are loosely grouped by the term "super-alloys" and include names such as Hastelloy, Waspaloy, Inconel, Rene and Nimonic. They are used frequently in aerospace and power generation industries where steel is not capable of handling the conditions. Slow cutting speeds are required to prevent work hardening of the material. High oil semi-synthetic coolants, high lube synthetic coolants and high viscosity EP neat oils are best for these materials. Machining Operations Metal is machined to change its size and shape, which is done by removing material. There are many different ways to machine metal with new techniques being developed regularly. Figure 18 gives a general graphic representation of the lubrication and cooling demands of ten common machining applications. While this chart might suggest that broaching always requires a neat oil for maximum lubrication and grinding always requires a synthetic coolant for maximum cooling, this is not necessarily the case, as many other factors come into play -– for example: work- piece metallurgy and hardness, cutting feeds and speeds, tooling type and end-user specific requirements (safety, environmental). The various machining operations are discussed in detail on the following page. Figure 18. Lubrication and cooling demands of common machining operations. Q12

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES