Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 262 of 385

Technical Training and Reference Info Metalworking Technical Training Cutting and Grinding 1 800 255 4417 www.castrol.com/GPS March 2017 Troubleshooting Potential Cause Problem Low Concentration High Concentration High Tramp Oil High Dirt/Fines Low Hardness (Soft Water) High Hardness Low pH High pH (cleaner contam.) Mechanically induced / Low fluid level High Chlorides Stagnant Fluid Metals Contam(Zn,Cr,Ni,Co) Personal Hygiene Lack of PPE Poor Coolant Flow Flow not directed to point- of-cut Poor Tool Regrind Low or high fluid temp Foam X X X X X X Residues X X X X Rust X X X X X Dermal Irritation X X X X X X X Chemical Odor X X Rancid Odor (bacteria) X X X X X Musty Odor (fungus) X X X X X Poor Tool Life X X X X X X X Poor Machining X X X X X X X Problems and Causes At a Glance Q25

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES