Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 284 of 385

Corrosion Preventives Technical Training and Reference Info Metalworking Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Corrosion Preventive Care There are several best practices that promote good rust protection performance and extend the service life of these fluids, as described below by fluid type. Care of Solvent-Based Corrosion Preventives Solvent-type rust preventives are generally selected by the user for their film type, film thickness and drying speed. When new, these features are primarily due to the ratio of solvent to film-forming material. Once introduced into service, solvent evaporation begins – leading a slow shift in the solvent/film material ratio with a decreasing solvent content and a proportional rise in film material. If allowed to continue without intervening practices, the film level will continually increase. What was once a nearly dry to touch light film may become a moderately heavy, oily/greasy film. Users may complain, packaging may become oil stained or greasy in appearance and additional cleaning may become necessary to remove the objectionable film or the dirt being attracted. If the solvent-based inhibitor is a water-displacing type (nearly all are), water may accumulate in dip tanks if the process is such that the parts being dipped are wet from a washing or machining operation. This water content must be managed through regular draining. Best Practice: Solvent-based rust preventives – dip tanks • Cover dip tanks with lids to prevent evaporation when idle, or if parts reside in the tank for extended intervals. Hinged lids are usually the most convenient design. This significantly reduces evaporation, especially in warm climates or heated areas. — Keeps out airborne dust — Improves fire safety • Dip tanks should have bottom drains with valves to drain off water that has been displaced from wet parts. Periodically drain away accumulated water. • Tank design should have open mesh or screened false bottoms. Prevents dipped parts or parts baskets from dropping into a layer of accumulated water. • Collected fluid in adjacent parts drainage areas should be returned to dip tank in a prompt fashion (every shift, or daily) to prevent contamination. Best Practice: Solvent-based rust preventives – spray applications • Rust preventive collected from overspray containment should not be recycled — Spraying process accelerates solvent evaporation rate significantly — Increase in film-forming ratio is rapid, contributing to heavier-than-desired film characteristics of used rust preventive. Care of Oil-Based Corrosion Preventives Neat oil fluids are much less volatile than solvent-based rust preventives, and concerns to preserve the oil to film-forming ratio typically are not warranted. However, if the neat oil inhibitor has water-displacing features, some care is needed. In addition, neat oil rust preventives that have vapor phase corrosion inhibitor (VCI) chemistry should be handled in such a way as to avoid depletion in dip tank applications. Best Practice: Neat oil rust preventives – dip tanks • Neat oil rust preventive dip tanks can benefit from tank covers, mostly to keep dust and other airborne contaminants out. Most dip tanks do not have filtration, and if dust gets into the tanks, it can easily be deposited onto the workpiece and interfere with rust protection. • Neat oil dip tanks with water displacing chemistry will benefit from bottom drains to remove collected water • The dip tanks should have a mesh or screen false bottom to prevent parts or parts baskets from dropping into any accumulated water or dirt Best Practice: Neat oil rust preventives – spray applications • Neat oil rust preventive collected from overspray containment can be recycled, but it is recommended that it is filtered prior to reuse. Q47

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES