Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Fundamentals of Lubrication Lubricant Characteristics and Additives Pour point is highly dependent on: • Viscosity: lower viscosity oils will have lower pour points • Oil type — Paraffinic mineral oils have higher wax content, leading to higher pour points — Naphthenic mineral oils have lower wax content and lower pour points — Synthetic oils can vary, but typically have lower pour points than equivalent-viscosity paraffinic mineral oils, primarily due to their higher VI Pour point depressant additives are available; they interfere with the wax crystallization at low temperatures and allow for better flow. These additives are frequently used in higher viscosity oils and oils developed for cold weather service. Flash and Fire Points The flash and fire points of a lubricant are determined in a lab by heating up the oil and passing a flame repeatedly over the top in the vapor space above it. Flash Point = The temperature at which the oil vapor will ignite but not continue to burn for more than five seconds. Fire Point = The temperature at which the oil vapor ignites and continues to burn for more than five seconds. These measures are generally used by health and safety professionals and maintenance personnel. They assess the oil's risk factor in various applications and conditions within the facility. Figure 30. Oxidation of an oil can lead to troublesome by-products. Acids Sludges Volatiles Gums & Lacquer Reduced flash point Corrosion & poor demul Sticking Valves Blocked filters & fine oil ways + O 2 oil Reaction accelerated by: • Heat • Water • Metals (copper, zinc, etc.) • Dirt • Entrained Air Oxidation Resistance Oxidation is the reaction of oxygen with the oil, which occurs naturally to break down the oil. It is generally a slow reaction, but is accelerated primarily by heat. It is also accelerated by such catalysts as water, metals (copper, zinc), entrained air, and dirt. The by-products of this reaction can be quite detrimental to the system (Figures 30 and 31). Oxidation of an oil can be tracked by measuring the weak acid level, known as Total Acid Number or TAN. Over time, the TAN will increase as the oxidation increases. Figure 31. Typically, oxidized oil is darkened due to the various by-products. R17

