Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 304 of 385

Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Fundamentals of Lubrication Our "oxidation rule of thumb" suggests that the rate of oxidation for mineral oils increases significantly at temperatures over 150˚ F. For example: if an oil at 150˚ F lasts for one year, that same oil will only last six months at 168˚F. For this reason, oils running consistently higher than 150˚F may benefit from the use of premium mineral oils or synthetics. The oxidation resistance of an oil can be measured in several ways, but the two most common tests are: TOST – Turbine Oil Stability Test • Oxygen passes through the oil, which is held at 95˚ C until TAN reaches 2.0 • Test duration is generally long (months to, perhaps years) • Result reported in "hours" • Conventional hydraulic oils last 2000-5000 hours • Castrol Tribol HM 943 lasts 18,000+ hours in this test (over 2 years!) RPVOT – Rotary Pressure Vessel Oxidation Test • Oil is pressurized with oxygen and held at 150˚ C until a specified pressure drop is reached • Much shorter test than TOST (~1-2 days); result reported in "minutes" • Can be used to test remaining oxidation resistance of used oils (common for turbine oils) Oxidation resistance is important for most oils, but especially those in long-term and high-temperature service such as turbine oils, hydraulic oils, gear oils and compressor oils. Synthetic oils generally have higher oxidation resistance and/or produce less egregious by-products, but this varies by type of synthetic. Lubricant Characteristics and Additives Oxidation Rule A mineral oil's life is cut in half for every 18ºF over 150ºF. Oxidation inhibitors work to slow oxidation by decomposing radicals, terminating free radicals and/or neutralizing oxidation by-products. In short: they eliminate open areas on the lubricant molecule that are potential reaction points for oxygen. Amine- and phe- nol-based additives are often used to increase an oil's oxidation resistance. Anti-Wear and Extreme Pressure Characteristics Anti-wear (AW) is the ability of a lubricant to prevent wear due to metal-to-metal contact, which causes friction generated through sliding or rolling motion. Extreme Pressure (EP) is the ability of a lubricant to prevent scuffing, scoring and seizure as load is increased. This is also referred to as "Anti-Scuff," especially by the American Gear Manufacturers Association (AGMA). AW and EP additives perform in a similar manner. They react with the metal surface under the right conditions of load and heat to form a protective, sacrificial layer to prevent metal-to-metal contact. The key difference is that AW additives tend to be milder in reaction than EP additives. Several lab tests are available for measuring the AW and EP characteristics of oils: • Four-ball EP / Four-ball AW These tests are the most common for assessing AW and EP • FZG Designed primarily for gear oils, but also used to assess the properties of other oil types such as hydraulic oils • Timken EP An older test still used to compare EP properties of lubricants • Falex Pin and Vee An infrequently used test, but can provide good results • Various hydraulic pumps tests (Denison, Eaton Vickers) Used to determine the AW performance of hydraulic oils R18

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES