Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 331 of 385

Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Hydraulics Fire-Resistant Hydraulic Fluids Polyol esters are the most common non-aqueous FR fluid due to their inherent high flash and fire points, excellent lubrication properties, good compatibility with seals and mineral oils, long sump life and low maintenance (similar to mineral oil). They are fully synthetic oils created through the reaction of a fatty acid with an alcohol. Conversion from mineral oil is relatively simple, since polyol esters have seal compatibility that is similar to that of mineral oils and they are usually compatible with mineral oils. Polyol esters should be routinely sampled and monitored, especially for water and total acid number (TAN). • Water can cause hydrolysis of the base fluid, leading to acid development and breakdown of the oil; therefore, the fluid should be checked regularly and water should be removed. Shell and tube heat exchangers and poor breathers are common ingress points for water. • TAN test should also be run regularly since polyol ester will tend to form weak acids over time. TAN is an indication of this breakdown and will help determine when to change the oil. Poorly formulated polyol esters will increase in TAN very quickly. Castrol Anvol SWX is formulated to resist this oxidative breakdown, thus greatly increasing service life of the oil and hydraulic components. Fluid Property Water Glycol Polyol Ester Fire Resistance ++ - Price per gallon ++ - Total Cost of Ownership Depends on conditions Lubricity - +++ Pump Life - +++ Pressure Capability - +++ Maintenance - ++ Biodegradability - ++ Waste Treatability - ++ Air Release - + Rust Protection - + + ++ Indicates increasing advantage +++ - Indicates disadvantage Figure 12. Comparison of the properties of the two most common fire-resistant fluid types. When comparing and choosing between the two most popular FR fluids – water glycol and polyol ester – the degree of fire resistance will be a key factor. Other factors to consider are shown in Figure 12 below. Filtration and Contamination Control Filtration and contamination control are critical in hydraulic systems, as many of the components used in hydraulic circuits are sensitive to various contaminants. These could include the following: • Solid — Metal chips, sand, dirt — Weld spatter, slag — Sealing material — Wear materials • Liquid — Water (free, dispersed and/or dissolved) — Process chemicals • Gas — Air (free and entrained) Contamination Sources Ingress of contaminants can occur via many areas of a hydraulic system (Figure 13). • New oil, while typically clean from the manufacturer, can pick up contaminants during shipping, storage, transfer and/or handling before it reaches the system. For this reason, filtering of new oil is recommended to ensure that these contaminants are removed prior to adding to the system. • Breathers are another common source of contaminants. As such, desiccant filtering breathers should be used to ensure that water and dirt are not "sucked in" from the atmosphere. • Internally generated wear materials can, in turn, go on to produce abrasive wear. R45

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES