Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 345 of 385

Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Greases and Bearings Figure 10. Four-ball EP Test. Top: overall test rig. Bottom: 3 lower balls mounted in the cup. Center: the resulting pyramid of welded balls at the end of the test. Grease Characteristics In both tests, the grease's resistance is determined as a percentage of grease washed off. The % loss is typically higher in the Spray-Off Test, since it is more aggressive than the Washout Test. The "water" in question can often be more aggressive than fresh water; for example, steel mill cooling water, which contains dirt, oil, slag, bacteria and other contaminants. It could also be a liquid other than water such as a metalworking coolant or process fluid. It is recommended to use a sample of the actual contaminating fluid in these tests so as to generate data closest to real world conditions. Load-Carrying Ability (EP) Greases are tested for properties of extreme pressure (EP, also called "anti-scuff") using many of the same tests that are used for oils. The most common of these tests are the Four-Ball EP Test and Timken EP Test. Four-Ball EP Test (Figure 10) • Three steel balls are held together in a cup and covered with the lubricant • The fourth ball is mounted in a spindle and put in contact with the lower set of balls at 1800 RPM • Load is gradually increased until the four balls weld together • The result is reported as the "weld load" • A weld load of 250 kg or higher is generally considered an EP lubricant • Loads of up to 800 kg are possible for very high EP fluids Timken EP Test • A test ring revolves at 800 RPM against a test block • Tests are run for 10 min with loads progressing in stages until scoring on the block occurs • The result is reported as the "OK load," which is the highest load that produced no scoring on the block — Non-EP lubricants will get <20 lbs. — Mild EP/AW lubricants will get 20-45 lbs. — High EP lubricants will achieve 50 lbs. or more as the OK load. R59

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES