Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Greases and Bearings Bearings Many components of industrial machinery may require grease lubrication, but the widest use of grease is in bearings. Bearings are critical components of equipment in almost every industry, so proper lubrication of them is important to efficient operation. Bearings are used to support a load, usually on a rotating shaft. They may support both radial and axial loads, help reduce friction and locate the shaft or load (Figure 13). Figure 13. Bearing supporting both a radial and axial load on a rotating shaft. Radial Load Shaft or journal Axial Load Bearing There are two main types of bearings: • Plain Bearings, and • Anti-Friction Bearings Plain Bearings The plain bearings most commonly found in industrial environments are called "journal bearings" and support radial loads only. They are simply a shaft (called the journal) supported in a hollow cylinder, or sleeve, which acts as the bearing surface. In most applications, the journal rotates and the sleeve or bearing is stationary. Plain bearings can be lubricated with oil or grease (or, infrequently, with solid lubricants or pressurized gas). The goal is to generate a full-fluid hydrodynamic film between the shaft and bearing when at normal operating speed and temperature (Figure 14). Figure 14. Plain journal bearing building an oil film. Shaft at rest. Boundary Lubrication Shaft begins to rotate. Mixed-film Lubrication Shaft at full speed Hydrodynamic Lubrication Determining the proper oil viscosity for journal bearings is dependent on the following factors and is primarily related to the Stribeck Curve (as discussed in Fundamentals of Lubrication section). Factor Relationship Linear Speed (DN factor: Shaft diam in mm x RPM) Higher speed requires lower viscosity Temperature Higher working temperature requires higher viscosity Load Higher load requires higher viscosity Bearing size (load bearing area) Smaller bearing size requires higher viscosity These factors can be used by lubrication specialists to calculate the proper viscosity oil to use. The bearing material is often made of a softer material than the shaft. This means the bearing will assume much more wear than the shaft, which is beneficial as the bearing is the component more easily replaced or adjusted (Figure 15). Typical bearing materials include: • Babbitt (most common) Tin babbitt: • 83-92% Tin • 6-8% Antimony • 4-8% Copper • <0.5% Lead Lead babbitt: • 75-84% Lead • 1-10% Tin • 10-16% Antimony • 0.5% Copper • Copper alloy (bronze) • Non-metallic (nylon or PTFE) It's important to note the metallurgical make-up of the bearing so that wear metals can be easily identified in oil analysis results. Figure 15. Babbitt bearing damaged in service. This is the lower half of a split bearing design, which sustained poor lubrication and misalignment. R61

