Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Greases and Bearings Failure Mode Description Appearance Solution Fatigue Sub-surface crack creation and propagation due to repeated contact stress. Pitting and spalling are the final results. • Reduce excessive loads • Check alignment and housing • Check bearing clearances • Redesign with higher capacity bearing • An ideal running bearing will eventually fail due to fatigue -- no solution Corrosion Chemical attack or rust. Bearing at rest under corrosive conditions will show rust (red), staining (black) or etching. • Eliminate contamination of cooling fluids, acids or other liquids • Check or improve seals • Upgrade to stainless steel bearings • Use corrosion resistant lubricants • Increase re-grease frequency to purge contamination Brinelling Deformation of metal surface due to impact of rollers or balls. Creates roller impact marks on the surface. • Avoid dropping or otherwise impacting bearing before installation • Avoid directly impacting bearing during installation False Brinelling Wear due to small vibratory movements between two surfaces. Also called "fretting corrosion." Often occurs during storage. • Correct the source of vibration • Tighten internal fits • Lock bearing during transportation • Store bearing on its side • Reduce viscosity or NLGI grade of the lubricant Contamination Solid debris leading to abrasive wear. Irregular dents or material embedded in raceways. • Check and improve seals • Eliminate ingress of particles • Improve filtration Lubrication Failure Fault due to poor lubrication. Accelerated wear rates and high heat (color change of the metal) are typical. • Confirm relubrication cycles • Check for plugged lines • Avoid contamination • Ensure proper viscosity/NLGI grade Thrust Loading Excessive thrust loading for the bearing design. Results in accelerated wear on one side of bearing. • Eliminate thrust load • Use a type of bearing designed for thrust loading (angular contact, tapered roller) Misalignment/ Improper Fit Installation error and/or misalignment. Wider wear path or wear path running from one side of race to the other. • Eliminate shaft or housing misalignment • Check for shaft bowing • Check dimensions and squaring of shaft and housings • Ensure proper bearing installation Electric Arcing Electricity flowing through the bearing. Individual arcs melt bearing surface and cause fluting. • Insulate bearings with nonconductive material • Check wiring and welding apparatus • Ground bearings Common Bearing Failures and Solutions Machine marks intact Machine marks gone Figure 27. Common bearing failures and solutions. R68

