Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Slideway Oils Slideway Oils Lubrication of Slideways The goal in lubricating plain ways is to generate a hydro-dynamic fluid film between the two flat surfaces, effectively separating the contact points and preventing metal-to-metal contact. This is achieved by developing an oil pressure "wedge" as the two surfaces move relative to each other (Figure 7). The thickness of the oil film – and thus the ability to separate the surfaces – is contingent on several key factors: • Oil viscosity/temperature — Higher viscosity aids in developing a better oil film, but a too-high viscosity can lead to fluid friction (resistance from the fluid itself) • Table area and load weight — Higher loads reduce the film thickness • Table speed — Speed is needed to develop an oil wedge/oil film • Rate of oil loss/replacement — Too little oil due to run-off, wash-off or extended re-lube intervals can lead to lack of oil film Viscosity of the oil is the property that quantifies its "thickness," or resistance to flow. It is affected by tem- perature, with viscosity going down as temperature rises. Table load and speed are other important factors directly affecting the thickness of the oil film. Load is often fairly constant, but speed varies greatly as the table moves back and forth, changing directions. When the table is stopped or is switching directions, the speed is zero, meaning that the oil film is minimal. As such, the lubricant must be formulated to compensate for this situation and prevent chatter and wear. In precision machining, the oil film thickness is critical to ensuring accuracy of the parts. Oil film thickness can vary by as much as 0.005", which is greater than some precision machining tolerances of 0.0001". In these cases, the oil film factors discussed above must remain very constant and controlled to ensure that a change in oil film thickness does not affect finish part quality. Figure 7. Development of an oil film as the top surface moves along a stationary bottom surface. Oil is drawn into the front and generates a pressure "wedge" to separate the surfaces. Lubricant Outlet Lubricant Inlet Force due to pressure Speed Pressure distribution Slideway Oil Characteristics Slideway oils must lubricate slides and ways effectively, but may also lubricate ball screws, bearings and other points on machine tools. They are generally "once-through" applications, meaning that the oil is not recovered or recirculated. The following are the key performance characteristics to consider: • Viscosity • Wear protection and stick-slip prevention • Resistance to coolant wash • Compatibility with water-based coolants • Corrosion protection Viscosity Viscosity is the most important characteristic of any oil and plays a major factor in the oil film developed between the metal surfaces. • ISO 68 is the most common viscosity grade recommended by machine tool manufacturers. • ISO 220 is often used on vertical and heavily loaded ways and is gaining in popularity for general slideway use to prevent wear and reduce oil usage. R72

