Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Slideway Oils Slideway Lubricant Selection Criteria The important factors in selecting the proper slideway oil are discussed below: OEM recommendation In most cases, the original equipment manufacturer (OEM) has done testing to determine the proper oil characteristics for optimum operation. End user requirements and experience End users often have their own requirements or chemical restrictions that limit use of certain fluids. Experience with equipment and past fluids used is also valuable. Load/weight As load increases, oil viscosity may need to be increased along with other design considerations. Way orientation Vertical ways can typically benefit by higher viscosity (often ISO 220) to help resist oil losses due to gravity. Metalworking fluid type and system conditions If significant amounts will end up in the coolant, the slideway oil should be designed for good compatibility and demulsibility for easy skimming. Slideway wear In situations with existing wear, adjustments may be needed to eliminate progression including different viscosity, higher anti-wear protection and/or better coolant resistance. Environmental consideration Biodegradability and reduced oil waste would be examples of environmental needs that would be specific to an end user. Dual-purpose requirements Some machine tools call for a dual-purpose hydraulic/way oil. This is often an ISO 32 such as Castrol Magna SW D 32, formulated to properly lubricate both applications. The oil (or grease, in some cases) may be delivered to the slideway by several types of lubricant delivery systems. These include: Single-Line Resistance This type of delivery system is also referred to as an orifice system or a Bijur® unit. It meters oil to a lube point through a resistance fitting (a.k.a. orifice or metering unit), which is, essentially, a flow control valve (Figure 12). The fittings are available in a variety of sizes to meet individual lube point needs. During a lubrication cycle, pressurized oil from the pump is sent to all resistance fittings for a given amount of time, as set by the machine. This is a "non-positive displacement style" system, whereby viscosity has a direct effect on the volume output of oil (higher viscosity = slower flow through the orifice). Amount of oil delivered to a lube point is determined by: Fluid viscosity Resistance fitting size Time between cycles (OFF time) Cycle time (ON time) Figure 12. Resistance fitting controlling the volume of oil flow to a given lube point. Image courtesy of Bijur Delimon. Lubricant Delivery Systems R75

