Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 243 of 385

Technical Training and Reference Info Metalworking Technical Training Cutting and Grinding 1 800 255 4417 www.castrol.com/GPS March 2017 Metalworking Fluid Types Emulsifiers are special polar compounds (negative and positive charge on opposite ends) that allow oil and water to come together into an emulsion. This is not a true solution; rather, oil droplets are suspended and scattered throughout the water (Figure 7). Each oil droplet has a negatively charged surface that attracts the positive end of the emulsifier, also called the lipophilic or "oil loving" end. As the emulsifier surrounds the oil droplet, water is attracted to its negative end, also called the hydrophilic or "water loving" end. This creates an oil droplet that remains suspended within the water. Figure 7. Polar emulsifiers surround the oil to form droplets suspended in water, creating an emulsion. The emulsion of a soluble oil is milky in appearance due to the dispersion of oil droplets throughout the solution reflecting light (Figure 8). It is often referred to as a "macro-emulsion." To ensure development of a proper emulsion, the soluble oil concentrate must be added to water, as the reverse could create an invert emulsion (water suspended in the oil). As a guide, remember the acronym: O.I.L. = Oil In Last. Figure 8. Milky emulsion of a soluble oil. The stability of the emulsion is important to its long-term performance. Electrovalent compounds, which break into positive and negative ions in water, are the worst enemy of the emulsion as they can interfere with the emulsifier/oil relationship. Acids, salts and hardness minerals (Ca+ and Mg+), in particular, can loosen or break the emulsion. Hardness will build over time as water evaporates, so the level should be monitored closely in soluble oils. Semi-Synthetic Coolants Semi-synthetic coolants are similar to soluble oils in that they use mineral oil (or some other oil type) to form an emulsion with water. As compared to soluble oils, they generally have lower oil content and form tighter emulsions that contain smaller oil droplets. Some manufacturers will refer to formulations using this smaller oil droplet chemistry as "micro-emulsions." They typically form translucent emulsions dependent on oil content in the formulation. They seek to deliver the oil lubrication benefits of soluble oils with the bio-resistance, cleanliness, and long sump life of synthetic coolants. Water is included in the concentrate to maintain its stability, although some manufacturers will add excess water to reduce their cost. A typical semi-synthetic coolant formulation may include: • Mineral oil (10 – 50%) • Emulsifiers • Coupling agents • Lubricant package (Boundary and EP) • Corrosion inhibitors • Buffers/amines • Biocide/fungicide • Defoamer • Water The emulsion stability of most semi-synthetics is excellent, allowing them to run longer in hard water conditions. The versatility and overall performance of this coolant type makes them the most commonly used in the industry. Oil Oil Oil Oil Oil Oil Oil Oil Oil Negative charges repel each micelle H 2 O H 2 O H 2 O H 2 O H 2 O Figure 9. Semi-synthetics form a tighter emulsion with smaller oil droplets than soluble oils. REPRESENTATION Lipophilic (oil-loving) Hydrophilic (water-loving) Na + Q6

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES