Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 260 of 385

Technical Training and Reference Info Metalworking Technical Training Cutting and Grinding 1 800 255 4417 www.castrol.com/GPS March 2017 Figure 26-1. Causes and solutions for common metal cutting problems. Troubleshooting Castrol can assist in determining the root cause of coolant system and machining problems. Contact your local representative for support. Common problems and their causes are contained in the table below and on the following pages. PROBLEM POTENTIAL CAUSE SOLUTION FOAM* High concentration Add water to reduce concentration to target range. High tramp oil Reduce leaks and use skimmers. Soft water Use water hardener additive or city water as natural source. Cleaner contamination Keep cleaners, mop water and other chemicals out of system. Low temperature Maintain coolant temperature above 72˚ F for best foam control. Mechanically induced Maintain proper coolant level. Reduce agitation and repair mechanical problems. Turn off unneeded flush lines and waterfalls. RESIDUES High concentration Add water to reduce concentration to target range. High tramp oil Reduce leaks and use skimmers High dirt/fines Correct or improve filtration system. Clean system thoroughly. Excess mist or splash Reduce flows; install protection; improve mist collectors. High hardness Use treated water (DI or RO). Dump system to remove hardness. CORROSION Low concentration Add coolant concentrate to increase to target range. High dirt/fines Correct or improve filtration system. Clean system thoroughly. High hardness Use treated water (DI or RO). Dump system to remove hardness. High chlorides Use treated water (DI or RO). Dump system to remove chlorides. Low pH Use pH booster additive. Determine cause of low pH (e.g., presence of bacteria). Improper storage Dry parts before storage. Avoid metal-to-metal contact. Hot, humid environment Increase concentration; improve ventilation; use a rust preventive. *Foam and air entrainment can occur due to mechanical problems or chemical problems. Mechanical problems may include low sump volume, high agitation, excessive fluid velocities, and damaged system components. Chemical problems may be related to high concentration, excessive tramp oil, soft water, improper fluid temperature, or contamination by another chemical. A simple shake test can help determine which type of problem exists. Vigorously shake a sample of the fluid in a clear bottle that is half full. If the foam breaks quickly, the coolant is performing as expected and mechanical problems exist. If the foam persists, a chemical problem with the coolant is occurring. Q23

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES