Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Metalworking Technical Training Cleaners 1 800 255 4417 www.castrol.com/GPS March 2017 Cleaner Types Solvent Cleaners Solvent cleaners have a diminished role in most modern manufacturing due to environmental concerns. Chlorinated halogen solvents were commonly used in the past for vapor degreasing, which is now mostly abandoned. They were effective and did not burn, but are practically banned due to ozone depletion characteristics. Non-halogenated hydrocarbon solvents are still in use, but contribute to VOC gases formed during evaporation; in addition, by being flammable, these raise concerns about flashpoints. If properly managed, hydrocarbon solvent cleaners can be recycled by distillation, often by high-tech washer styles (Figure 2). In other cases, small solvent washers are used to de-grease maintenance equipment or production parts from small runs. Castrol markets a high-flash hydrocarbon solvent cleaner, promoting the use of as much safety as possible with this cleaner type. Aqueous Process Cleaners Generally, most aqueous cleaners are based on alkaline chemistry with a pH higher than 7, but some special application cleaners are acidic to help remove stains and oxidation. The most common acidic cleaners are either Figure 2. Modern solvent washer with distillation recovery. Courtesy of Durr Ecoclean. Figure 3. The pH scale. pH below 7 is acidic and pH above 7 is alkaline or basic. phosphoric acid or citric acid based (orange cleaners). Castrol does not market acidic cleaners. Emulsion cleaners are the third type of aqueous cleaners, using oil-containing emulsion chemistry similar to that used in water-soluble metal removal coolants. They can be effective in lifting oily soils and will leave a light oil film to provide a barrier for rust protection. To have a point of reference in understanding the pH value of commonly known chemistries, please review the pH scale in Figure 3. Any material below pH 7 is considered acidic and pH values above 7 are considered alkaline (also known as basic). A pH of 7 is considered neutral. Industrial washers generally fall into two categories: spray washers and immersion washers. (Detail on equipment design follows,) As such, alkaline cleaners are tailored to be effective in the specific washer design, and thus they are generally either a spray cleaner or an immersion cleaner. The key differences between spray cleaners and immersion cleaners are: • Spray cleaners are designed to be low foaming, often coupled with oil rejecting characteristics. Oil rejection enhances the effectiveness of oil skimming devices. • Immersion cleaners have the capacity to lift and absorb soils; in addition, when immersion washers are enhanced with ultrasound, ultrasonic cleaners will let microbubbles form to support the soil lifting features of ultrasound. The chemistry of immersion cleaners is more likely to generate foam. Q28

