Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Fundamentals of Lubrication Tribology and Friction Tribology Tribology is the science and technology of friction, lubrication and wear. It is a term to describe the study of interacting moving surfaces and encompasses aspects of physics, chemistry, metallurgy, material science, mechanical engineering, chemical engineering and applied mechanics. Friction is the resistance to relative motion between two bodies in contact. Studies estimate that as much as one-third of all usable energy is lost to friction and wear. • Reactive maintenance due to high friction and wear conditions costs three times that of planned maintenance and proper lubrication. • In addition to energy waste, friction and wear greatly affect equipment reliability, maintainability, safety, service, life and environmental factors. One of the primary functions of a lubricant is to reduce friction. By reducing friction, you reduce the energy required to perform work. Two types of friction (dry friction and fluid friction) and two modes of friction (sliding and rolling) will be discussed below. Dry Friction Although a metal surface may appear smooth to the naked eye, it actually consists of many peaks, or high spots, called asperities. Dry friction is the impacting of asperities between two surfaces in contact without a lubricant film for protection. Figure 1 shows how the asperities of two surfaces come into contact to create friction. The asperities block free movement of the surfaces, requiring a force (called the frictional force) to overcome them. Even highly polished materials will show asperities under magnification. As shown in Figures 2 and 3, a precision watch gear and a highly machined surface both show asperities and significant surface roughness upon high magnification. The real contact area between two surfaces may be much lower than the calculated area because only the area of the asperity peaks – not the entire surface – is in contact (Figure 4). This means that localized loading at the asperity contact areas can be extremely high. Asperity Contact a b Real Contact Area Figure 1. Two metal surfaces in contact with impacting peaks (called "asperities") creating friction. Figure 2. A gear from a precision watch under high magnification shows asperities. Figure 4. Due to asperity interaction, the real contact area may be far less than the nominal calculated area (a x b). Figure 3. A highly machined surface under 2000X magnification with significant surface roughness. Real Contact Area (shaded areas) < Nominal Area (a x b) R2

