Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 343 of 385

Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Greases and Bearings Grease Characteristics NLGI Grade Worked Penetration (tenths of mm) Description 000 445 – 475 Extremely soft, pourable. Commonly used for slideways and leaky gearboxes. 00 400 – 430 Very soft. Also used for gears and slideways. 0 355 – 385 Soft. Good choice for central lube systems. 1 310 – 340 Most common choice for central lube systems. 2 265 – 295 Most common choice for manual lubrication. 3 220 – 250 Often used for very high speed spindles. 4 175 – 205 Rarely used. 5 130 – 160 Hard. Infrequently used as a brick grease. 6 85 – 115 Very hard. Infrequently used as a brick grease. Figure 7. NLGI grades based on penetration measurement. Typically, multiple NLGI grades are offered in the same grease. These different grades are produced simply by varying the ratio of oil and thickener, i.e., more oil produces a softer grease, and less oil produces a harder grease. Grease manufacturers often put the NLGI grade in the name of the product; for example, Castrol Molub-Alloy 777-2 ES, where the "-2" represents the NLGI grade. In general terms, softer greases work better for slower speeds because the grease will flow back to the metal surface quickly and lubricate it. Similarly, harder greases generally work better for higher speeds because they will lubricate the metal and then "get out of the way" so as not to interfere with the fast-moving rollers. Since the oil/additive components of the grease provide most of the lubrication, some bleed of oil is important from the thickener in order to reach the metal surfaces. Too much bleed will lead to oil loss and hardening while too little bleed will not provide enough lubrication. As such, proper formulation and manufacturing of the grease is necessary to achieve the appropriate balance. Base Oil Viscosity and Type As discussed in the Fundamentals of Lubrication section, viscosity is generally the most important characteristic of an oil. This applies to grease, as well. High speed applications will require a grease with low viscosity base oil while low speed, heavily loaded equipment needs a high viscosity base oil. For bearings, the linear speed (DN factor) must be calculated to take into account both the RPM and the size of the bearing. DN factor = D x N where D is the bearing bore diameter in mm and N is the RPM General guidelines for grease base oils, assuming moderate temperature range: • High linear speeds (DN >90,000) & low loads: ISO 100 and below • Medium linear speeds (DN 30,000 to 60,000) & medium loads: ISO 150, 220 • Low linear speeds (DN < 30,000) & high loads: ISO 320, 460 and above Greases with ISO 100 base oil are often specified for motor bearings. Greases with ISO 150 and ISO 220 base oil make good general purpose greases. Those with ISO 320 and above are typically used for higher load and slower speed applications. Base oils can be mineral or any type of synthetic, but mineral oils are by far the most common. Dropping Point The dropping point is the temperature at which the grease passes from a semi-solid to a liquid state. This may be due to actual liquefaction of the thickener; or, more commonly, just bleeding of the oil. For this reason, it is not called the "melting point." NLGI 1 and 2 are the most common grease grades as they are typically suitable for manual greasing and central grease systems. R57

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES