Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 350 of 385

Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Greases and Bearings Many lubrication methods exist for getting grease to a bearing, but the most common types include: • Sealed ("lubed for life") • Manual • Single point lubricators • Centralized lube system Sealed Bearings Sealed bearings are not intended to be re-lubricated; rather, they simply run until failure, and then are replaced. They are commonly found in wheel bearings and some motor bearings. They are lubed for life, so the only maintenance that can be performed is to replace the bearing. Positives: Contamination prevention, reduced lubricant consumption, improved housekeeping, no regular maintenance required Negatives: Limited bearing life dependent on the lubricant life, higher friction due to rubbing of seals, potentially higher temperatures, maintenance requires bearing replacement Manual Greasing Manual greasing should purge spent grease and refill the bearing with the proper volume of fresh grease. This is done through the use of a grease gun connected to a grease fitting on the bearing housing (Figure 21). Alternatively, difficult-to-reach locations may be piped out to a central area for ease of re-lubrication. Bearing Lubrication Figure 20. Sealed bearings. Figure 21. Typical grease fittings, grease gun and bearing housing. Bearings and housings are normally packed 33% to 50% full of grease, but consult the bearing manufacturer's recommendations for proper amount. The amount of grease is very important, especially in motor bearings. Too much grease in a bearing can damage seals, cause leakage and develop excessive heat. In contrast, an insufficient amount of grease will soon leave a bearing "starved" of lubricant, resulting in bearing damage. The bearing manufacturer may recommend re-grease volumes, but the industry-accepted calculation from SKF is based on the size of the bearing as shown below. Grease amount calculation (based on SKF industry- accepted formula): G A = 0.005 x D x B where G = grease mass in grams D = bearings outside diameter (in mm) B = total bearing width (in mm) Grease or zerk fitting R64

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES