Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 354 of 385

Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Greases and Bearings Failure Mode Description Appearance Solution Fatigue Sub-surface crack creation and propagation due to repeated contact stress. Pitting and spalling are the final results. • Reduce excessive loads • Check alignment and housing • Check bearing clearances • Redesign with higher capacity bearing • An ideal running bearing will eventually fail due to fatigue -- no solution Corrosion Chemical attack or rust. Bearing at rest under corrosive conditions will show rust (red), staining (black) or etching. • Eliminate contamination of cooling fluids, acids or other liquids • Check or improve seals • Upgrade to stainless steel bearings • Use corrosion resistant lubricants • Increase re-grease frequency to purge contamination Brinelling Deformation of metal surface due to impact of rollers or balls. Creates roller impact marks on the surface. • Avoid dropping or otherwise impacting bearing before installation • Avoid directly impacting bearing during installation False Brinelling Wear due to small vibratory movements between two surfaces. Also called "fretting corrosion." Often occurs during storage. • Correct the source of vibration • Tighten internal fits • Lock bearing during transportation • Store bearing on its side • Reduce viscosity or NLGI grade of the lubricant Contamination Solid debris leading to abrasive wear. Irregular dents or material embedded in raceways. • Check and improve seals • Eliminate ingress of particles • Improve filtration Lubrication Failure Fault due to poor lubrication. Accelerated wear rates and high heat (color change of the metal) are typical. • Confirm relubrication cycles • Check for plugged lines • Avoid contamination • Ensure proper viscosity/NLGI grade Thrust Loading Excessive thrust loading for the bearing design. Results in accelerated wear on one side of bearing. • Eliminate thrust load • Use a type of bearing designed for thrust loading (angular contact, tapered roller) Misalignment/ Improper Fit Installation error and/or misalignment. Wider wear path or wear path running from one side of race to the other. • Eliminate shaft or housing misalignment • Check for shaft bowing • Check dimensions and squaring of shaft and housings • Ensure proper bearing installation Electric Arcing Electricity flowing through the bearing. Individual arcs melt bearing surface and cause fluting. • Insulate bearings with nonconductive material • Check wiring and welding apparatus • Ground bearings Common Bearing Failures and Solutions Machine marks intact Machine marks gone Figure 27. Common bearing failures and solutions. R68

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES