SportsTurf provides current, practical and technical content on issues relevant to sports turf managers, including facilities managers. Most readers are athletic field managers from the professional level through parks and recreation, universities.
Issue link: http://read.dmtmag.com/i/96775
FieldScience paction as measured by soil resistance was studied. The deep tine aerifier reduced soil resistance from 3.5 inches down to 7.6 inches, but did not reduce compaction in the top 3 ½ inches. The standard tine unit did reduce resistance significantly in the top 3 inches, but had no effect deeper in the soil. The long-term effects of continued aerification with a standard tine unit fitted with solid tines (5/8-inch diameter) for 3 years in a row, at a depth of 2.3-5 inches, showed that there was significantly more resistance than in unaerified plots. This indicates that a layer of compacter soil (known as a "pan" or "aerification pan") had developed near the bottom of the tine stroke. This illustrates the need for periodic deep tine aerification to avoid this problem. The pan of compacted soil was less severe when hollow tines were used, but still could build up over time. When the surface hardness of the turf was measured using a Clegg hammer, all forms of aerification produced a softer surface at least for one week after treatment. The standard tine aerifier with hollow tines tended to produce the softest surface. CONCLUSIONS • Compaction of turfgrass soils lowers the percent macropores in the soil; a decrease in macropores limits soil aeration, which hurts root growth. • Core aerification, especially solid tine, may not help eliminate thatch. • Effects of aerification in heavily trafficked soils may be short-lived (about 1 month). • Diagnostic techniques for detecting compacted soils, such as infiltration measurements or soil penetrometer readings, are widely variable, even across supposedly uniform surfaces such as a putting green. • Compacted "pans" develop over time at the bottom of the tine's penetration into the soil, especially when using solid tine equipment. • Deep tine equipment is more effective at reducing soil compaction at depths below 2.5 inches. ■ Beth Guertal is a professor of agronomy & soils at Auburn University; Dave Han is an associate professor of agronomy & soils at Auburn University. 10 SportsTurf | December 2012 Things we measure in turfgrass compaction experiments SOIL BULK DENSITY Bulk density is defined as the mass of a unit volume of dry soil. To collect a bulk density reading a sample of known depth and diameter (typically 6 inches deep and 3 inches in diameter) is removed from the soil. The soil sample is dried and weighed and the bulk density is expressed as the mass per volume (grams per cubic centimeter). As the soil is compacted the bulk density increases, because more soil particles are forced into a smaller volume and soil pore space is reduced. Sandy soils typically have a higher bulk density than soils high in clay or loam, because sandy soils have few of the very small pores associated with fine-textured soils that have clay and organic matter. Additionally, sandy soils that contain sand in a range of sizes (as is a typically sand-based putting green) are already tightly packed, as smaller sand grains fit in between larger. Typical bulk densities for clay and silt loam soils may range from 1.0 to 1.5 g/cm3, while the bulk density of sand-based soils may range from 1.3 to 1.8 g/cm3. At the upper end of these ranges the bulk density is great enough that root penetration may be inhibited. As comparison, the USGA recommendation for bulk density of putting green rootzone mix is 1.2 to 1.6 g/cm2. It's important to note that bulk density is highly variable from location to location. One sample will usually not be an indicator of the bulk density of an entire field or turf area. consists of two metal rings (one around 12 inches in diameter and the other around 18 inches), with the smaller placed inside the larger. Water is added to both rings until a height of water is maintained for a period of time, which indicates that the underlying soil has become saturated.The drop in the height of water inside the smaller ring during a given period of time is used to calculate the saturated hydraulic conductivity, which is reported in units such as inches per hour. Small-diameter (6 inches) infiltrometers can be purchased from many turf supply catalogs. The intended use of these units is to provide turf managers the ability to measure infiltration rates of their turf soils quickly and directly in the field. Because research has shown that double-ring infiltrometers with an inside ring diameter of at least 12 inches produce the most accurate measurements of water infiltration, the accuracy of 6 inch diameter rings is a concern. A 1991 research study by D.H.Taylor compared single and double-ring infiltrometers with inner-ring diameters of 6, 8 and 12 inches on a variety of turf areas, from golf greens to football fields. They found that infiltration rates varied widely within each sampled turf area, even when the largest diameter rings were used. The conclusion from their work was that infiltration rates measured with ponded water should be used only as a rough estimate, and results should be used with caution. CLEGG IMPACT READINGS SOIL PENETROMETER READINGS A soil penetrometer is a device used to measure the compaction of the soil. What is actually measured is the resistance, or amount of pressure needed to push a tipped rod through the soil. The rod tip is equipped with a load-sensing cell, and the soil strength is recorded as the tip is pushed down through the soil. Soil penetrometers used for research are very sensitive, and require some practice to use correctly to obtain accurate measurements. They are also very expensive, about $6,000. HYDRAULIC CONDUCTIVITY Hydraulic conductivity is the ease with which soil transmits water. In turfgrass what we often measure is the saturated hydraulic conductivity, which occurs when all soil pores are filled with water. Saturated hydraulic conductivity is typically measured using a double ring infiltrometer, which Typically used to measure the hardness of a turf surface, the Clegg hammer calculates the hardness of a surface based on its reaction to a weight dropped on the surface from a consistent height. A diagnostic tool for discovering differences in surface hardness due to aerification treatments, work has also started on calibrating Clegg hammer readings to field hardness or softness. For example, a survey of 24 high school athletic fields had Clegg values that ranged from 33 to 167 Gmax. For comparison, a tiled concrete basement floor had a Gmax reading of 1280, which was reduced to 260 when the floor was covered with a carpet pad. In another study, compacted Kentucky bluegrass plots had a value of 206 Gmax, while plots that were not compacted had a value of 93. A survey of college and professional soccer players compared their perceptions of soccer fields that had been used to collect Clegg data. Typically, fields with a hardness reading between 90 and 120 Gmax could not be differentiated by players. www.sportsturfonline.com