Pro Pickup

April 2013

Propickup Digital Magazine

Issue link: https://read.dmtmag.com/i/119529

Contents of this Issue

Navigation

Page 41 of 44

COOLANTFILTERINSTALL By Steve Temple Adding an oil-coolant filter can prevent headgasket failure in the Ford 6.0L T he symptoms were obvious, but not the cause. Mechanics at BD Diesel were seeing a string of headgasket failures on Ford's 6.0L engines. Some technicians blamed them on an insufficient number of head bolts, others the design of the EGR cooler. Only after tearing down a number of faulty heat exchangers (for both the EGR and oil system), and also comparing the variance between oil and coolant temperatures did the source of the affliction become obvious: sludge. When murky coolant was drained and allowed to stand for a time, fine silt settled out. The source? Evidently sand from the casting of the 6.0L engine blocks can leach out of the metal and into the water jacket. (Which, oddly enough, doesn't seem to be a problem with other Ford diesels, nor other brands.) As the sediment plugs up the oil cooler, the problem gets compounded. Less coolant flows to the EGR cooler, and the engine runs hot. Then the fluid begins to break due to the high temps, and isn't able to do its job. And the thin vanes of the EGR cooler suffer damage as well, until you end up with a molten mass of metal. Of course, that means plenty of work for diesel repair shops. "Fixing oil and EGR coolers is a common problem, and keeps Photos by Steve Temple us busy," admits Tim Anderson of T&A Performance. A rebuild kit runs about $400, and nine to 12 hours of labor. Even worse, he points out that a 260-degree oil temp will peg the coolant temp gauge (if the truck has the latest calibration), and 300 degrees melts just about every plastic part under the hood. At that point, the engine is not repairable, a total loss. You can avoid this expensive scenario with a simple fix: install a coolant filter. That, and follow a few other maintenance tips (noted below). Installing a coolant filter usch as BD Diesel's takes bout an hour, or slightly more if you're doing it the first time. BD Diesel's Cheyne Beukes notes that the filter is a "passive system," meaning that it's not mounted in front of the water pump (not feasible), and doesn't filter on every pass of fluid, since the feed line is from a T-fitting off the heater system. But that's good because in the unlikely event there's a restriction in the hose, it can't cause any damage to the engine. The kit is mounted in-line with the engine coolant hoses and includes a filter head, spin-on filter, mounting bracket, hoses, clamps, fittings and mounting hardware, along with a bypass valve to PROPICKUP DIGITAL PP0413_Ford Coolant Filter.indd 42 3/8/13 9:06 AM

Articles in this issue

Archives of this issue

view archives of Pro Pickup - April 2013