Issue link: https://read.dmtmag.com/i/1495554
800-580-7554 www.pulsetech.com ppc@pulsetech.com EASY INSTALLATION 15 Easy to Install Solar Pulse Solar Panels SP-3, SP-7,SP-12, SP-25 and 12V ERV Unit Solar Installation Instructions WARNING: Do not hold the positive and negative lugs at the same time while the unit is active (receiving sunlight). It may cause a slight electric shock. The SolarPulse unit is now ready. Once the panel is exposed to sunlight, SolarPulse will begin charging your battery and prevent- ing/removing the buildup of lead-sulfate deposits on the battery plates. Note: For the most effective results, we suggest you install SolarPulse permanently. However, if your vehicle or equipment does not allow for a permanent install, a temporary placement will not affect the performance of SolarPulse. The circuit box can be mounted using any of the following methods: Two round-head screws, industrial adhesive, heavy-duty dual lock or double-sided tape (not included). After cleaning the install area, mount the box close to the battery so that the lugs can reach the terminals. DO NOT attach it to the battery itself. Also make sure the box is located in a location where it won't be disturbed and the LED is visible. Connect the positive (+) wire to the positive (+) battery terminal. After removing the nut from the bolt securing the battery clamp to the positive terminal, slip the round metal lug at the end of the positive red SolarPulse wire onto the bolt until it sits next to the clamp. Feed the solar panel cable through any exist- ing opening in the vehicle or equipment into the battery compartment. Connect the quick disconnect plugs on the solar panel and the circuit box cables. Slip a round washer (not included) onto the bolt until it sits next to the lug. Replace the nut onto the bolt and tighten it until it se- cures the lug and washer against the clamp. Do not over tighten. Repeat steps 4-5 above to connect the negative (-) black SolarPulse wire to the negative (-) battery terminal. If you wish to remove excess wiring between the solar panel and circuit box, they can be cut and spliced together. If you wish to extend the length of the solar panel wires, they can be spliced with up to 10-feet of the same gauge wire as the model you are installing. NOTE: Only the wires between the solar panel and the circuit box can be spliced. DO NOT splice the wires between the circuit box and battery. Circuit box includes an LED on top. LED will light when lugs are attached to the battery terminals and solar panel is installed and receiving sunlight. It shines steady in full sunlight and dims in indirect sunlight. Mount the solar panel using any of the fol- lowing methods: Four round-head screws*, industrial adhesive, heavy-duty dual lock or 3M VHB double-sided tape (not included) (not included). It should be mounted where it will have direct sunlight. *Screws cannot be used with the 12V ERV Unit If needed, use plastic cable ties (not in- cluded) to secure the circuit box wires to the battery cable or other secure area near the battery. This will keep the wires from being damaged or interfering with any moving engine parts. WARNING: Any solvents that may be harmful to plastic should not be used on or near the unit. 1 4 7 2 5 3 6 ONLY FOR 12V ERV MODEL INSTALLATIONS