Issue link: https://read.dmtmag.com/i/703077
I DA U N I V E R S A L J u l y -Au g u s t 2 0 1 6 39 such as mineral and vegetable oils, benzene/petrol, ordinary diluted acids, and alkalis." However, there is a tradeoff between ACN content and low temperature fl exi- bility. e higher the ACN content, the more resistant the hose is to fl uids, but the worse it will be for low temperature fl exing, which can lead to cracking and failure when the hose fl exes when it is below its stated operating temperature. e way chemicals in the recipe bond together gives the hose its diff erent resistances, he says. Hoses are built like sandwiches with several layers of material stacked on top of each other, but all those materials must bond with each other. "How easily the materials bond is important," Garceau says. "Otherwise, hose failure could lead to delamination while in use. e inner tube could separate and rip itself out." A hose's pressure rating is determined by its reinforce- ments, he says. Hoses are constructed in layers, starting with an inner tube, then alternating layers of rubber and reinforcements, such as steel wire. Each reinforcement layer is placed to work with the layer above or below it, so when the hose is pressurized, it creates a hydraulic balance. is balance restricts the hose from moving too much under pressure. If there is no balance, the hose twists or "bounces" under pressure and could start to come apart due to the forces from the pressurized fl uid, he explains. While hoses under the hood of vehicles are usually fairly stationary and don't move around very much, hoses used on a piece of equipment that has a fl exible joint, like a backhoe, must fl ex reliably in all conditions. Parker also engineers its hoses with a number of SAE-tested and approved additives to increase resis- tance to ozone and ultraviolet (UV) light. Without such additives, constant exposure to direct sunlight (like on a piece of construc- tion equipment) degrades the rubber, causing it to break apart and fall off in chunks, which is made worse by any fl exing motion. "Additives impart their characteristics and properties to the rubber compound," he says. "Other additives include processing aids, such as waxes and oils, and abrasion- resistant and fi re-resistant polymers added to the hose cover. ● machinedesign.com/hydraulics, Kyri McDonough, Parker Hannifi n Corp5/16 Caption: Certain materials let hoses be built with thinner layers, allowing for decreased outside diameters and increased bend radii while maintaining the same level of performance. e chemistry for hoses is chosen based on what they are going to be used for, but the goal for all hoses is the same— – maximum durability, high fl exibility, and long service life. Hoses are expected to perform in both extreme heat and cold, so they are tested in some of the worst conditions.

