Issue link: https://read.dmtmag.com/i/74547
CUSTOM RIGS 2 aluminum sleeve over the tag-end and main cable. Attach the release cable to the latch pivot on the lower door. Crimp the supplied latch is tripped into the "closed" position. Run the loose end of the cable up through the cable clip and pull it taut. Then secure with the clamp screw. 3 Attach the supplied cable- retaining clip to the sole- noid. Then make sure the 5 a ground, so attach the ground wire to the truck frame. Run the switch wire to the release switch. 4 Attach ground (black) and switch wires to the solenoid. The door is not Always use split-loom tubing over any wiring in the truck to prevent shorts and abrasions. We ran the wires through the cab-door frame and then down through the floor to the release switch. 6 78 | Overdrive | August 2012 nient and well-hidden. Attach the solenoid wire to one terminal and the fused (hot) lead that runs to the battery to the other. The fuse should be located within 18 inches of the battery. Test to make sure everything functions properly. Mount the emergency release switch, which controls the pop lock, anywhere that's conve-