Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Metalworking Technical Training Cutting and Grinding 1 800 255 4417 www.castrol.com/GPS March 2017 Caring for Metalworking Fluids Tramp Oil Inevitably, oil from the machine in the form of way lube, hydraulic oil or spindle oil will make its way into the metalworking fluid. This is the most common type of contaminant in metalworking fluids, and is called "tramp oil." When water-based cutting fluids are contaminated by tramp oil, problems can occur. For example, the sulfur in some hydraulic and way oils may cause black stain problems, especially when parts are stored in contact with each other. Also, tramp oil provides nutrients for bacterial growth in cutting fluid mixes. As a result, coolants that normally would not go rancid often develop strong, "Monday morning" odors when left stagnant for several days. Heavy oil contamination may cause the formation of sticky residues on the splash areas of machine tools. Tramp oil affects the rate of filtration and clarification of cutting and grinding fluids. With positive filters, a small amount of tramp oil contamination (less than a half percent) often aids filtration by promoting agglomeration of grit and fines and creating a thicker filter cake. Too much oil, on the other hand, is apt to cause "blinding" of the media, blocking passage of the fluids. This results in excessive filter indexing and paper usage. Heavy tramp oil contamination of water soluble fluids may promote poor tool life and loading of grinding wheels, which in turn lowers production as the operator has to stop more often to dress the wheel. Finally, tramp oil contamination affects refractometer readings. The line on the scale becomes increasingly fuzzy and the readings indicate a richer mix than actually exists, which may lead to lower-than-expected lubricity, rust protection and bacteria control. What to Do Whenever possible, fix leaks and use lubricants that resist emulsification. Most hydraulic oils have good demulsibility and also resist oxidation and sludging. Leaks should be prioritized to fix the largest ones first. Figure 23. Belt or disc skimmers can be installed to remove excess tramp oil. Image ourtesy of Abanaki Corporation. Slideway oil usage can be reduced by using a high- quality lubricant with tackifier to prevent coolant wash-off, such as Castrol Magna SW, Magna SW D, Tribol SW 1066, and Tribol SW MWO way lubricants. Keep machine sumps cleaned out, especially on grinders. Tiny metal chips and swarf as well as particles of abrasive grit from the grinding wheel can promote wearing of lubricant seals. Replacing these seals is troublesome and often expensive, so the job is often "put off." Preventing grit recirculation by regularly cleaning out cutting fluid sumps is the best way to forestall insidious damage. Magnetic filtration is an ideal way to remove ferrous grit and fines. Belt and disc style skimmers are the most economical means of removing tramp oil from the system (Figure 23). A one-foot wide belt skimmer is capable of removing several drums of floating tramp oil per day. These styles are most effective in off-shifts, as the oil will separate best when the coolant is at rest. For larger systems with higher levels of tramp oil, a coalescer or centrifuge may be required. In any case, this equipment must be regularly cleaned and maintained to ensure proper operation over time. Q20

