Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Fundamentals of Lubrication Lubricant Characteristics and Additives Viscosity Index (VI) As previously discussed, an oil will drop in viscosity as its temperature goes up and increase in viscosity as its temperature goes down. But each oil has a different rate of viscosity rise and fall with temperature. This rate of change is described by the oil's viscosity index. In a viscosity-temperature chart like the one shown in Figure 27, a high VI oil will have a flatter line, because its viscosity does not change quickly with temperature. Conversely, a low VI oil will have a steeper line because its viscosity changes more rapidly with temperature. VI is determined by measuring the viscosity in centistokes at 40˚C and 100˚C and calculated using a formula based on its slope. Viscosity Index is an empirical number, meaning that it has no unit of measure. Figure 27. Viscosity index of two lubricants, showing that Lube A has a much slower viscosity change with temperature (higher VI) than Lube B. Typically, synthetic oils have a naturally higher VI than mineral oils do, but polymer additives are available to boost the VI of mineral oils for wide temperature applications. At low temperatures, the polymer chains remain compact and offer little resistance to flow (Figure 28), thus lowering the viscosity. As the temperature increases, the chains start to "uncoil" and interfere with each other; this restricts oil from flowing and increases the viscosity. Typical viscosity index of various oils: Naphthenic Mineral Oil 40 Paraffinic Mineral Oil 90-100 PAO Synthetic 140-180 PAG Synthetic Up to 350 Figure 28. Polymer behavior at various temperatures, providing increased viscosity index. Pour Point The pour point of an oil is the depressed temperature at which it no longer flows (Figure 29). This is not considered the freezing point, as it has not necessarily turned to a solid, but is simply the temperature at which the viscosity has increased enough to prevent flow. Knowing the pour point is useful primarily for cold temperature situations, particularly at start-up when the oil is cold and not moving. Rule of Thumb: The lowest useful temperature of a fluid lubricant is a minimum 15˚F to 20˚F above its pour point, at system start-up. 100˚F 20˚F -10˚F Fluid Flow Slow Flow No Flow (Pour Point) Figure 29. Pour point of an oil is the temperature at which it no longer flows. R16

