Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Gears Figure 2. Common gear terminology. Gear Introduction Gears are the most common way to transmit power from one revolving shaft to another. Different combinations of gears are responsible for increasing speed, decreasing speed and changing the direction of the shaft. Gears are usually found in meshed pairs. The smaller gear is called the pinion and the larger gear is called the bull gear, ring gear or simply just the "gear." The main purposes of the gears are: • Transmit power • Change speeds • Change direction of rotation Gear Terminology Typically, gears are used either to reduce or increase speeds. In a common application, a gear reducer is used between a motor and a piece of equipment to reduce the rotation speed while increasing the torque to perform work. When the speed difference requirement between the input shaft and output shaft is large, there are often multiple sets of gears within a single gearbox to accomplish this. The ratio of the input and output shaft speeds is called the "gear ratio." The pinion is always the smaller of the two gears in a meshing set. The "driver gear" is the one creating the movement between a meshed gear set; the "driven gear" is the other gear in the set which is being moved by the driver gear. For example: In a speed reducer, the motor turns the pinion, which in turn moves the bull gear. In this case, the pinion is the driver gear and the bull gear is the driven gear (Figure 1). This is the most common arrangement found in industrial applications. Key gear terminology is shown in Figure 2. Figure 1. Meshed gear set in a speed reducer where pinion is driving the bull gear. Pinion the smaller of the two gears in a meshing set. In a speed reducer, it is the "driver gear." Driver gear creates the movement between a meshed gear set Gear ratio the ratio of the input and output shaft speeds, e.g., 3.76:1 Pitch Circle the radius of which is equal to the distance from the gear axis to the pitch point. Pitch Point the point of tangency of two pitch circles and is on the line of centers. Pitch point is a point where most of the power transfer occurs and a rolling action happens between gear teeth. R23

