Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 310 of 385

Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Gears Gear Introduction The gear geometry influences both the load capacity and the sound level of a gearbox. When properly designed and manufactured, gears operate smoothly and quietly and have adequate load capacity to transmit the required power for the design life. Most industrial gears use an "involute" gear tooth shape to accomplish this. Key terminology of an involute gear tooth profile is shown in Figure 3. Figure 3. Involute gear tooth terminology. Addendum the distance (or general area) from the pitch line up to the tooth tip Dedendum the distance (or general area) from the pitch line down to the tooth root Pitch Line the line near the center of the tooth where most power transfer occurs and rolling action happens between the teeth Gear Tooth Action Figure 4 shows the meshing action of involute gear teeth in a spur gear, which follows these steps: 1. As two teeth are about to engage, there is sliding contact. This occurs in the dedendum of the driver gear and the addendum of the driven gear. 2. As the teeth get further into mesh, rolling contact occurs as they go through the line of action (pitch line near the center of the tooth). 3. Finally, as the teeth are about to disengage, they slide as they come out of contact. This occurs in the addendum of the driver gear and the dedendum of the driven gear. Figure 4. Meshing action of involute gear teeth, which can be described in simple terms as Sliding > Rolling > Sliding. Pressure angle "E" Pitch Circle Gear Face width Line of action Line of Centers Tangent line to the pitch circle Dedendum Addendum Sliding > Rolling > Sliding The contact point moves along a straight line through the pitch point, which is tangential to the base circles of the gears. The straight line is called the pressure line because it is the normal contact point for involute teeth. • Sliding is at a maximum at the start of the engagement, which occurs toward the gear's pitch line and away from the pinion's pitch line in a speed reducer. • Sliding reduces to zero at the pitch point (pure rolling, as with roller bearings) and then increases again to another maximum at the end of engagement. Once the contact point moves into the vicinity of the pitch line, the number of gear tooth pairs in contact becomes minimal. As a result, the normal Hertzian* contact load is maximum in this region. In addition, spalling is normally found in this region. For this reason, there is an intuitive similarity between roller bearing spalling and gear pitch line spalling phenomena. *Hertzian stress is the combination of shear, tension and compression stresses when gears mesh. 4. The direction of sliding reverses at the pitch line. Sliding always occurs away from the pitch line on the driver teeth and toward it on the driven gear. 5. The kinematics of an involute gear meshing pair is best described as: Sliding together > Rolling at the pitch line > Sliding apart. Addendum Dedendum Root fillet Active profile Start-of-active profile (SAP) Pitchline Tooth edge Tooth edge Tooth tip Face width R24

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES