Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 317 of 385

Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Gears Open Gear Lubricant Classifications and Requirements High-Viscosity Synthetic Oils: Formulated from PAO, PAG or esters • Some of these oils use polymers to substantially boost viscosity, so shear stability should be verified. • High-viscosity synthetic oils contain EP agents and rust and corrosion additive systems; they may also contain solid lubricants. • Reduced fluid friction produces lower pinion and gear operating temperature and improved gear efficiency. • These oils are useful at high and low operating temperatures. • High-viscosity synthetic oils have a higher initial purchase cost than traditional open gear lubricants, but offer longer life and reduced lubricant usage. The selection of a base oil viscosity for open gear lubricants is based on ambient temperature, gear operation, method of application and pitch line velocity. Figure 9. Typical appearance of a pinion lubricated with high- viscosity synthetic oil; Castrol Optigear Synthetic 800/2200 gear oil is shown here. AGMA 9005 outlines the viscosity recommendations for a variety of open gear applications. These include con- tinuous and intermittent lubricant applications for both splash and pressure fed systems. The standard further delineates the choices based upon ambient temperature and type of operation. In addition to the AGMA specifications, different OEMs (such as Falk and Sevedala) of machinery and open gearing units have their own benchmark tests and specifications. Methods of Lubricant Application Enclosed Gears Methods of lubrication for enclosed gears are: Splash/Immersion: This is the most common method of lubricant application for enclosed gears. This method consists of a gear partially immersed in oil, allowing the action of the gears to distribute the oil to the various working surfaces, and possibly including the bearings (Figure 10). • A typical enclosed gearbox at relatively low speeds (less than 5,000 fpm pitch line velocity) is splash lubricated. Generally, the large, low speed gear is allowed to dip into the oil bath. • Slingers and guides may also be used to direct the oil onto other gears and bearings. • With splash lubrication, it is important to maintain the specified oil level in a gear box. — If the level is too low, it can "starve" the gears of oil and increase heat and wear. — If the level is too high, oil can be churned, creating excess heat and foam and leading to failures of the oil and/or gears. • The breather should be fitted with a filter element and desiccant to prevent ingress of contaminants and moisture. Figure 10. Splash lubricated gearbox with oil channels for the bearings. Normal oil level is about 1/3 the height of the lowest gear Multiple reductions Breather Splash lubrication Level plug (no site glass) Drain plug Baffle Bearing lubrication R31

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES