Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Gears Methods of Lubricant Application Pressure Feed: For higher speeds (greater than 5,000 fpm pitch line velocity), a pressure feed system is used. It supplies larger volumes of oil to the gears for cooling and lubrication. • Oil is pumped from the reservoir and recirculated to the gear spray nozzles (Figure 11). • This type of system allows for straining or filtering of the oil, external cooling and independent feed lines for the bearings. Figure 11. Enclosed pressure feed lubricated gear box for greater than 5,000 fpm pitch line velocity. STRAINER or FILTER PUMP CHECK VALVE OIL COOLER BEARING FEED LINES FLOW SIGHT RELIEF VALVE Open Gears As previously discussed, some open gears are actually enclosed in a housing, but are lubricated like an open gear. The methods of lube application for open gears are: • Intermittent Spray — Lubricant is sprayed intermittently to the gearing at defined intervals. — This method is done most commonly with a central lube system, but occasionally is done by hand — Lubricant is typically "once-through," meaning it is not captured for re-use. • Sump/Idler Immersion — Lubricant is carried to the gears from the sump via the lowest gear or via an idler gear. — This method can be highly susceptible to contamination. • Full Pressure Circulation — This method consists of a pressure-fed oil spray to the gears, which circulates the lubricant to filter it and improve distribution to the gears. — Lubricant is captured and re-used. — This method may be combined with sump/idler immersion for improved lubrication reliability. • Gravity Feed/Force Drip — This method's basic system relies on gravity or mechanical pressure to continuously supply lubricant to the gears. — This simple delivery system is best used only for non-critical open gearing. Intermittent Spray is the most common method of lubricant application for open gears. This system has many very attractive advantages along with some disadvantages, as outlined below: Advantages of Intermittent Spray Systems • Low cost of installation • Does not require tight gear guards • Reliable when maintained properly • Easy-to-adjust application cycles and lubricant application rates • Properly dispense a wide variety of lubricant types Disadvantages of Intermittent Spray Systems • Require dedicated monitoring and maintenance to maintain system integrity • Spray nozzles can be subject to clogging by the lubricant • Can vary in output and reliability when ambient temperature changes occur R32

