Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 320 of 385

Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Gears Gear Failure and Trouble Shooting Though both spalling and pitting are common forms of surface contact fatigue, spalling results in a more rapid deterioration of surface durability than pitting does. In addition, Spalling often induces early failure by severe secondary damage, which is a more destructive surface failure mode for gear contacts. Such secondary damage can result in tooth breakage initiated by a severe spall on the contact surface, as well as friction or heat-induced surface seizure or complete spalling over all of the contact surfaces. Gear Wear and Failure Modes The most common types of gear failures are as follows: Adhesive wear (Scuffing). Usually caused by insufficient oil film or lack of EP, resulting in metal-to-metal contact. The heavily localized stresses cause smaller metal particles to break away. Plastic deformation. Occurs under extreme loads when the yield strength of the material is exceeded. The gear material flows plastically and gets deformed. Fatigue. Occurs due to high contact stresses. Fatigue is a progressive failure consisting of three distinct stages: Stage 1, crack initiation; Stage 2, crack propagation; Stage 3, fracture. Corrosion. Occurs when gear material chemically reacts with its environment. Electric discharge. Caused when an electric current passes through a gear; resulting in gear damage. The main causes of gear failures can be summarized as: • Metal-to-metal contact due to insufficient lubricant film • Insufficient lubrication due to low quantity of oil, wrong/poor lubricant choice or lube system delivery failure • Ingress of contaminants (dirt, water) • Repeated loading, unloading and/or shock loading • High loads or load exceeds strength of the material • Misalignment or incorrect dimensions of gears • Improper manufacture and/or handling Practical Recommendations and "Rules of Thumb" • Cold Start-Up – The lowest useful temperature of a fluid lubricant is 15°F to 20°F above its pour point at system start-up. • Synthetic versus Mineral Oil – Typically, synthetics are used for high temperatures (above 170° F), low temperatures (below 0° F) or large variances in temperature (> 50° F). If a mineral oil can do the job, it's usually your best choice. • Viscosity – If gear wear is experienced, a high- performance additive system may help. Insufficient viscosity or overloading may also be part of the cause. Increasing the viscosity by one ISO or AGMA viscosity grade above OEM specification can help reduce wear and will usually be acceptable to the gearbox. • Additives – Unless the gearbox manufacturer specifies an R&O gear oil, an EP gear oil is almost always recommended. Note: EP additives may be aggressive to gears with yellow metal such as the bronze wheel in many worm gear drives. R34

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES