Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Metalworking Technical Training Cutting and Grinding 1 800 255 4417 www.castrol.com/GPS March 2017 Water Quality The quality of city-supplied water varies greatly by region within the United States. Water hardness levels and typical regions where they are found are shown in Figure 12. Hardness Level Grains per gallon (gpg) Parts per million (ppm) U.S. Region Where Found* Soft 0-3 0-50 Southeast, North- east, Northwest Medium 3-7 50-120 ID, MT, TN, parts of TX and Northeast Moderately hard 7-10 120-170 Midwest, West, parts of TX Hard 10-15 170-250 Midwest, North, Southwest, parts of TX Very hard 15+ 250+ WI, MN gpg x 17.1 = ppm Figure 12. Hardness levels and U.S. regions where found. *Note: water quality varies within regions, so check water properties in the lab for specifics. Incoming water sources may be treated to reduce impurities. Treatment is generally recommended for water with moderate to high hardness and chloride content to improve the properties of the diluted metal- working fluid and promote long fluid life. The two most common treatment methods are deionization (DI) and reverse osmosis (RO). Deionization is a chemical process whereby the dissolved ionic salts are removed from the water. The deionizing unit uses two ion exchange resins to remove the positive and negative ions. Reverse osmosis uses a membrane that allows the water to cross freely but significantly retards charged ions. Water softening systems using salt (such as NaCl or KCl) are not recommended for metalworking systems, as they do not eliminate ions but simply exchange them for less aggressive ones. The remaining ions will still promote corrosion, making softened water unsuitable for coolants. Water softeners may be used prior to RO units to promote improved efficiency and life of the membranes. Workpiece Metallurgy Modern machining practice involves the cutting, grinding and shaping of a vast range of metals and their alloys. Each has its own particular machining characteristics, with some being easier and others more difficult to work with. Each metal and alloy has been graded under a standard set of conditions to give an overall "machinability" rating, which is readily available within the metalworking industry and online. However, each material also has its own machining peculiarities, and these have a bearing on the type of cutting fluid selected. The general degree of difficulty for metal types as it relates to the requirements of the coolant is shown in Figure 13. LABEL x y Low 0 1 Medium 0 5 High 0 10 Material and Machining Severity Rating Cast Iron 1 Copper/Brass/Bronze* 2 Magnesium 3 Low Carbon Steel 4 Medium Carbon Steels 5 Aluminum** 6 Tool Steels 7 Stainless Steels 8 Titanium Alloys 9 High Temp/Nickel Alloys 10 Low Medium High MATERIAL MACHINING SEVERITY *Exception would be oxygen-free copper, which would be more difficult **Aluminum types vary greatly. Machinability is generally good but stickiness & surface finish requirements are challenging. Figure 13. Approximate severity of machining by metal type. Note: this is a generalized list; alloy severity can vary greatly within a given metal type. *Exception would be oxygen-free copper, which would be more difficult **Aluminum types vary greatly. Machinability is generally good but stickiness & surface finish requirements are challenging. Q9

