Issue link: http://read.dmtmag.com/i/814629
Corrosion Preventives Technical Training and Reference Info Metalworking Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Corrosion Preventive Types Different chemistries can be utilized to meet corrosion protection requirements. All have a film-forming component and a carrier, which disperses the film- forming component(s) and carries them to the metal surface. Corrosion preventives fall into the following categories based primarily on the carrier type: Solvent-Based • Solvent carrier, with film-forming components • Dewatering chemistry • Demulsification chemistry • May have fingerprint suppression chemistry • Can have components to resist acid fumes Oil-Based/ Neat Oils • Base oil carrier, with film-forming components • Can have dewatering chemistry and demulsification chemistry • Can have components to resist acid fumes and suppress finger prints • Can have vapor-phase corrosion inhibitors to provide extended shelf life • Will have lower VOC content than solvent-based rust preventives Aqueous • One class is synthetic (oil-free) with passivating chemistry film • Others are based on emulsion chemistry, designed to leave a light oily film Thixotropic • Solvent, oil and wax suspension-based chemistry – superior protection Specialty Products • Wax emulsion-based chemistries, leaving a film that is both protective and lubricating for subsequent operations Solvent-Based Corrosion Preventives Solvent-based rust preventives are the most common type. They can be formulated for fast dewatering and drying to leave light to imperceptible films for short term protection such as in-process protection for partially finished parts or for finished parts prior to assembly. Most short-term fluids protect parts adequately for six months, if properly applied. Solvent-based inhibitors with a higher film-forming content can provide up to 18 months of indoor protection and even some outdoor protection if parts are covered by tarpaulins or shed roofs. The speed of drying is controlled in greater part by the selection of the solvent carrier. The other influencer of drying speed is the amount of film-forming content. Lower flash solvents will give the fastest drying, with the most common fast drying solvents in commercial use having a flashpoint at about 105°F. However, this fast drying increases the potential for fire, and many customers avoid the use of lower flash solvents due to the safety risk (and are often encouraged to do so by their insurers). The other classes of solvents available and appropriate for rust preventive use result in inhibitors grouping in flashpoints at about 140° F, 155° F, 180° F and 235° F. The use of solvents also permits very thin barrier films for protection, with the thinnest potential films being less than one micron in thickness. The heaviest solvent-based rust preventive films are over five microns due to high film-forming content. The published estimated film thicknesses are based on a laboratory standard calculation, in which steel panels are weighed prior to coating, dipped in the fluid and then left to hang in a vertical orientation for 24 hours, during which time drainage and drying occurs. At the end of the 24 hour drying cycle, the panels are reweighed, and the increase in weight is determined to be the quantity of film content on the panel. The area of the panel is then used to calculate the volume of film on the panel, in theoretical thickness. Q39

