Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 292 of 385

Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Fundamentals of Lubrication Lubrication Figure 11. Converging wedge pressure distribution. (Note: the top surface is tilted exaggeratedly for demonstration purposes). Lubricant Film and the Lubrication Regimes The fundamental goal of lubrication is to develop a lubricant film between moving surfaces to prevent metal-to-metal contact. To generate a load-carrying oil layer, the formation of a converging, wedge-shaped pressure film is necessary (Figure 11). As the tilted pad is moved across the stationary surface, lubricant is forced to the inlet, thus resulting in pressure distribution, as shown. This increased pressure provides the necessary force to raise the tilting pad off the stationary surface. If the speed and viscosity are great enough and/or the load small enough, hydrodynamic lubrication will result, whereby surfaces are fully separated by the oil film and no contact occurs. Lubricant Force due to pressure Velocity Pressure distribution A full fluid film separating the surfaces is not always possible, so the following lubrication regimes may exist depending upon actual conditions: Regime I: Hydrodynamic Lubrication • Named for hydro (fluid) and dynamic (motion) • Complete separation of surfaces by a fluid film • In theory, no wear occurs Regime I: Hydrodynamic Lubrication h >> R h = height of lubricant film R = height of asperities (surface peaks) h R Regime II: Mixed Film Lubrication • Most common lubrication regime • Separation of most surface peaks • Some surface peaks come in contact, so wear occurs Regime III: Boundary Lubrication • Must rely on EP/solid film additives • Many surface peaks come in contact • Wear accelerates Figure 12. The three lubrication regimes. Regime I: Hydrodynamic Lubrication h >> R h = height of lubricant film R = height of asperities (surface peaks) h R R h Regime II: Mixed Film Lubrication h R h = height of lubricant film R = height of asperities (surface peaks) R h Regime II: Mixed Film Lubrication h R h = height of lubricant film R = height of asperities (surface peaks) Regime III: Boundry Lubrication h 0 h = height of lubricant film Regime III: Boundry Lubrication h 0 h = height of lubricant film R6

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES