Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Fundamentals of Lubrication Types of Wear Fatigue Cyclic stresses causing fracture or breakage. Fatigue life • A properly run and lubricated part will eventually fail due to fatigue (which should take a long time). Premature fatigue may be the result of overloaded equipment or improper lubrication. Fretting Deterioration (oxidation) of surfaces caused by vibration. Also called "fretting corrosion" due to the red oxides produced. Fretting is common on the inner ring of bearings where they meet the shaft. Erosive Wear Removal of surface material by impinging particles. Erosive wear is important, especially in hydraulic and pneumatic systems. Hydraulic valves are highly susceptible, with the valve edges being most prone to erosive wear. High Pressure Hydraulic System High Pressure Fluid Flow Wear Debris Particles Under high pressures or high fluid velocities, particles are forced against metal surfaces, causing metal removal. Again, we see that wear debris is produced, which will accelerate wear rates. Not all wear is considered "bad." The running-in period of newly installed parts will actually increase the real contact area of the metal surface. Running-in helps with hot spots, work hardening and contact area improvement. Destructive wear modes can be minimized through proper lubrication (per the Lubrication Rule), appropriate lubricant additives, sound maintenance practices and good contamination control techniques. If the proper interference fit does not occur between the bearing and shaft, vibration can occur and lead to the fretting corrosion seen here. R9

