Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 299 of 385

Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Fundamentals of Lubrication Base Oil Types PolyAlphaOlefin (PAO) is created by polymerizing a simple olefin and is considered a group IV base oil (Figure 16). PAOs are the most common synthetic base oils due to their all-around excellent properties and lower cost as compared to other synthetics. Organic esters are considered the highest quality base oils and are more expensive to produce than PAOs. They are incredibly stable at very high temperature ranges. They electro-chemically bond with metals for a continuous lubrication film at both low and high temperatures. PolyAlkyleneGlycols (PAG) have a variety of uses as industrial oils due to their extremely high VI and excellent lubricity. They can often consolidate multiple oil viscosity grades and be used year-round in very cold outside applications. The low coefficient of friction makes them especially useful for worm gear applications, which have very high sliding friction to overcome. Group III oils (Figure 16) are also considered synthetic molecules due to the high degree of processing required to produce them. They are commonly used in synthetic engine oils and are slowly gaining more use in industrial applications. Fluid Compatibility As a general rule of thumb, fluids should always be considered incompatible until tested in the laboratory. Many consequences of incompatibility can occur such as fluid thickening, fluid thinning, additive dropout and residue formation. Figure 22 provides a very general guideline for fluid compatibility of base oils. When converting from one fluid type to another, the level of flush needed is dependent on fluid compatibility, as follows: • Compatible Fluids — Some old oil may be left behind with little or no detrimental effects — Level of flush should be based on a goal of removing as much spent fluid as possible while considering the time/cost commitment — The more old oil left, the greater the detrimental effect on the new oil due to oxidation by-products and contamination • Incompatible Fluids — Old fluid must be removed as much as possible using physical means to remove from reservoirs, filters, lines, valves cylinders, etc. — Full, detailed flush is required to remove any trapped residual fluid Mineral Oil PAO Water Glycol Polyol/ Diester Phos Ester Veg Oil Poly Glycol Mineral Oil - PAO - Water Glycol - Polyol & Diester - Phosphate Ester - Vegetable Oils - Polyglycol (PAG) - = Compatible = Incompatible (detailed flush needed) Figure 22. Compatibility of base oils. This is a guideline only and should not replace lab testing. R13

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES