Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Fundamentals of Lubrication ISO Viscosity Grade Viscosity Range, cST at 40° C (104° F) +/– 10% of Grade 10 9.0 – 11.0 15 13.5 – 16.5 22 19.8 – 24.2 32 28.8 – 35.2 46 41.4 – 50.6 68 61.2 – 74.8 100 90.0 – 110 150 135 - 165 220 198 - 242 320 288 - 352 460 414 - 506 680 612 - 748 1000 900 - 1100 1500 1350 - 1650 Lubricant Characteristics and Additives As shown in the previous section, base oils are a large portion of the finished lubricant and each has its own properties. To further develop the properties needed for a fully formulated oil, additives are used extensively. While additives can't overcome a poor quality base oil, they can improve upon an already good one. In this section, the most important lubricant characteristics will be discussed along with the additives used to improve them. Some of the key physical properties of lubricants include: • Viscosity • Viscosity Index • Pour Point • Flash and Fire Points • Oxidation Resistance • Anti-Wear and EP characteristics • Corrosion Resistance • Foam Control Viscosity Viscosity is a measure of a fluid's resistance to flow and is often referred to as the "thickness" of the oil. It is typically the most important property of any oil as it plays a critical role in the development of a proper oil film (see Figure 13, Stribeck Curve). • Low viscosity oils are used for applications with higher speeds, lighter loads and lower temperatures. • Conversely, high viscosity oils are used with lower speeds, higher loads and higher temperatures. The viscosity of an oil changes based on temperature, with viscosity dropping as temperature increases (and vice versa) as shown in Figure 23. Low High Temperature Figure 23. The relationship between viscosity and temperature. High Temperature = Low Viscosity (oil droplet is thinner) Low Temperature = High Viscosity (oil droplet is thicker) Figure 24. ISO viscosity classification system that is commonly used for industrial oils. The main viscosity classification for industrial oils is the ISO system (Figure 24), which uses an oil's kinematic viscosity at 40˚C (104˚F) measured in centistokes (cSt) or mm2/s to determine its corresponding viscosity grade. Industrial equipment manufacturers use this system to specify the viscosity grade required, i.e., ISO 46 anti-wear hydraulic oil. R14

