Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Hydraulics Figure 2. Schematic of complete hydraulic circuit with various components. Hydraulic System Components Today's hydraulic systems vary from basic systems to highly complex, numerically controlled units that are capable of performing a large assortment of work. These systems contain multiple components that control the movement, direction, volume and pressure of the hydraulic fluid along with conditioning equipment and a holding reservoir. Key components of a hydraulic system include: • Pumps • Valves • Actuators (cylinders and hydraulic motors) • Reservoir • Filters/Breathers (see Filtration and Contamination Control section) M Pump Valve Valve Valve Valve Cylinder (actuator) Breather Filter Filter Oil / Reservoir Pumps Pumps are used to create flow of the hydraulic fluid throughout the system. By themselves, they move the fluid but do not create pressure. Resistance to fluid flow within the hydraulic system, such as a load applied to a cylinder, is what creates the pressure. Hydraulic pumps are positive-displacement pumps. They trap a given amount of fluid and displace it into the discharge pipe, in comparison to non-positive pumps such as centrifugal types that use centrifugal force to sling the fluid to discharge. Positive-displacement pumps may be "fixed displacement" or "variable displacement." Fixed displacement pumps move a given amount of fluid with each pump rotation regardless of pressure or load on the system. Variable displacement pumps produce variable volume output (down to zero output) depending on feedback from the system such as pressure or load. The most common pump types are: • Piston pumps • Vane pumps • Gear pumps Piston Pumps Piston pumps have two main types: radial and axial. Both use multiple arrangements of a piston within a cylinder to take in a given amount of fluid and discharge it to the system. Piston pumps are commonly used where high pressures are required. Inline axial piston pumps are the most common type (Figure 3). They utilize a swashplate mounted at an angle to the axis of rotation. As the swashplate rotates, the angle causes the pistons to move in and out of the cylinders, thus drawing in fluid via input ports and subsequently pushing it out via the outlet ports. Since each of the multiple pistons is in a different position at any given time, output flow is constant. Figure 3. Variable displacement, inline axial piston pump. Case Drain ~5-8% of total flow (new pump) Swashplate Piston Inlet Outlet Variable flow compensation R38

