Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 327 of 385

Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Hydraulics Hydraulic System Components Actuators Hydraulic system actuators are the components that accomplish the actual work. There are two basic types with several sub-types: • Hydraulic Cylinders (Linear) — Single Acting — Double Acting • Hydraulic Motors (Rotary) — Gear, Vane, Piston — Fixed or Variable Displacement — Uni-directional or Bi-directional Hydraulic cylinders (e.g., linear actuators) are by far the most common type of actuator. These allow linear movements up and down or back and forth. Hydraulic cylinders utilize a piston and rod design whereby the flow of fluid to one side of the piston causes it to move within the cylinder, which in turn allows the rod to move linearly and perform work. • Single-acting cylinders use hydraulic pressure to move the piston in only one direction, relying on the load or a spring to act in the other direction. • Double-acting cylinders (Figures 9 and 10) use hydraulic fluid to move the piston in both directions. Bronze Bushing Rod Wiper Rod Seal Piston Seals and Bearings Figure 9. Cutaway diagram of a double-acting hydraulic cylinder. Figure 10. Simplified drawing of a double-acting hydraulic cylinder. Fluid flow to the bottom line will put pressure on the bottom of the piston, causing the rod to lift a load upward. Fluid flow to the top line will cause the rod to retract, thus lowering the load. Hydraulic motors (e.g., rotary actuators) produce a rotary motion and resemble hydraulic pumps working in reverse (with a few modifications). Hydraulic pumps use an electrical motor to generate rotary input, which in turn rotates the pump to create fluid flow output. Hydraulic motors, working in reverse of this, use the fluid flow input from the system to create a rotary motion output to perform work. They come in types similar to those of pumps, including piston, vane and gear motors with various design considerations such as fixed or variable displacement and uni-directional or bi-directional movement. Reservoir The reservoir is often considered to be just a holding vessel for the oil. But in fact, the reservoir facilitates a number of important functions for conditioning the oil. For example: • Heat: Provides time for the oil to cool • Solids: Drops solid particulate • Liquid: Allows for water to settle out • Gas: Provides residence time for entrained air and foam to be released The size of the reservoir is important, as it not only must provide the system with the capacity needed to perform work but also allow the residence time needed to accomplish the above-listed functions. Note: When using water glycol fire-resistant fluid, reservoirs should be sized larger as these fluids tend to entrain more air than other types. General rules-of-thumb for minimum reservoir size: Mineral oil (and many synthetics): Reservoir Size = 2-3X pump output Water Glycol: Reservoir Size = 4-5X pump output The reservoir can be a major source of contamination into the system. As such, reservoirs are best equipped with a good filtering breather, quick-connect fitting with filter for oil additions, large clean-out ports, sight gauge and temperature gauge. They should not be easily opened to the atmosphere. R41

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES