Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 329 of 385

Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Hydraulics Fire-resistant (FR) hydraulic fluids are used in areas where accidental release of the fluid can create a fire risk. Hydraulic Fluid Types Zinc-free anti-wear additives offer a number of advantages, including: • Environmental — Elimination of zinc in the waste stream • Performance — Extended life of hydraulic servo and proportional valves — Lower sludge formation • Water compatibility — Less additive dropout and sludge in the presence of water — Improved filterability in the presence of water • Coolant compatibility — Improved coolant compatibility (when leaks get into water-based metalworking fluid) HVI (high viscosity index) oils have an additional agent formulated into the fluid to increase the viscosity index of the base oil. Higher VI allows the oil to maintain viscosity more evenly over a wide temperature range. This VI increase is often accomplished via the addition of a long-chained polymer. If the proper polymer is not chosen, it can shear in service readily via the pump, thus causing loss of viscosity and VI. Base fluids other than mineral oils are much less common for hydraulic oils, but may be used to achieve additional requirements. These fluids include the following: • Synthetic PAO – used for longer life, especially at high temperatures • Synthetic Ester – used for longer life, improved system cleanliness and/or biodegradability • Vegetable Oil – used for biodegradability and/or high lubricity Additional hydraulic fluid types are covered in the Fire-Resistant Hydraulic Fluids section, below. Fire-Resistant Hydraulic Fluids FR fluids are not fire-proof, but have been approved by Factory Mutual to have reduced fire hazard as compared to mineral oils. However, all fluids will burn under the right conditions, so proper safety precautions must be utilized. Plant safety personnel should conduct a risk assessment to determine how the fluid could escape, what ignition sources are present, who/what will be affected by a fire and the necessary mitigating actions and equipment, including the type of hydraulic fluid required. FR fluids can be broken into two broad categories: Aqueous and Non-Aqueous. • Aqueous fluids contain some amount of water, which acts to prevent fire. The other portion of these fluids contains substances to provide lubrication, rust protection and wear protection. Generally speaking, they have higher fire resistance than non-aqueous fluids, but are poorer lubricants and require higher levels of maintenance. • Non-aqueous fluids contain no water, relying on the properties of the base oil or additives to provide fire resistance. Typically, they are better lubricants and have lower maintenance requirements than aqueous fluids do. R43

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES