Castrol GPS

GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES

Issue link: http://read.dmtmag.com/i/814629

Contents of this Issue

Navigation

Page 338 of 385

Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Hydraulics Hydraulic Fluid Sampling and Oil Analysis 2/10/17 System Name: Mold Oscillator Hydraulic System Capacity: 350 gal System Type: High Pressure Hydraulic w/ Servos System Pressure: 3200 psi Hydraulic fluid: Tribol HM 943/46 Sample frequency: Monthly Property Method Name Target Corrective Actions Viscosity Kinematric Viscosity +/- 10% of new oil High Viscosity: Check for wrong fluid added to system. If oxidation rate is high, this could lead to high viscosity. Change oil if necessary. Low Viscosity: Check for wrong fluid added to system. Check for water contamination. Change oil if necessary. Cleanliness ISO Particle Count 16/14/11 or better Investigate filters and breathers. Investigate other ingress points and maintenance activities that could lead to contamination. Use filter cart for minimum 4 hours and resample. Oxidation Rate Total Acid Number <1.0 over new oil Check oil temp to ensure it is within proper range. Check for water and metal contaminants which will speed up oxidation rate. Change oil when TAN reaches 2.0. Water Karl Fisher < 250 ppm Investigate potential source of water from heat exchanger or washdown activities. Check breather. Check other ingress points and openings in system. Check water level in new oil. Use vacuum dehydrator until water level drops below 250 ppm. Anti-wear Additive (Phos) Spectro >50% of new oil High Phos: Check for wrong fluid added. Change oil if necessary. Low Phos: Check for wrong fluid added. Investigate wear metals to determine if poor lubrication is leading to use of AW additives. Check oil temp to ensure operating viscosity is within range. Wear Particles (Fe, Cu, Sn, Ni, Cr) Spectro <50 ppm Investigate sources of wear. Check oil temp to ensure operating viscosity is within range. Run Analytical Ferrography testing. Contaminants (all other elements) Spectro <20 ppm Investigate sources of contaminants. Investigate other ingress points and maintenance activities that could lead to contamination. Test packages and analysis targets for each unit should be developed in conjunction with your oil supplier and/or oil analysis lab. The basic tests and typical targets for various fluid types are shown in the Figure 29. Figure 29. Common hydraulic oil analysis tests and typical targets for various fluid types. Mineral Hydraulic Water Glycol Polyol Ester VISCOSITY +/- 10% X X X VISCOSITY INDEX Viscosity change over temp Report X X SPECTRO Elemental analysis for additive & wear metal levels Varies X X X WATER < 200 ppm X X X TOTAL ACID NUMBER Indication of oxidation < 2.0 over baseline (mineral) < 5.0 over baseline (polyol) X X ISO PARTICLE COUNT Particles in various size ranges System dependent X X X FOAM Pass X PH +/- 5% of typical X ALKALINITY Rust inihibitor level Product specific X CLARITY Clear, no haze X FREE OIL Oil contamination None X TEST Description Typical Target Figure 28. Example of a control plan that documents sample frequency, oil analysis tests, test targets and corrective actions. R52

Articles in this issue

Links on this page

view archives of Castrol GPS - GUIDE TO INDUSTRIAL PRODUCTS AND SERVICES