Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Compressors Types of Compressors A compressor is a mechanical device used for compressing air or other gases. Compressed air is used in most facilities to provide power for performing such tasks as operating air tools at high speed, driving cylinders and linear actuators, clamping work in place, cleaning hard-to-reach areas, atomizing paint and putting test pressure on vessels and equipment. The main types of compressors include: • Reciprocating • Rotary screw • Rotary vane • Centrifugal Reciprocating Compressors A reciprocating compressor is a positive displacement machine that uses a piston contained within a cylinder to produce compression. The piston traverses the cylinder, "sucking in" the gas (typically, atmospheric air) at one end of its stroke and then compressing the air when it reaches the other end of its stroke (Figure 1). Reciprocating compressors may have one stage of compression (single stage) or multiple stages to achieve the desired pressure (up to 250 psig). Figure 2 depicts a two-stage model where the larger cylinder acts as the first stage and the smaller cylinder acts as the second stage to further compress the gas. An intercooler may be present between stages to reduce the heat generated during compression. Figure 1. Piston and cylinder within a reciprocating compressor. Reciprocating compressors have two locations requiring lubrication, each with its own requirements. These include crankcase and the cylinders. The crankcase and cylinder lube systems are usually separate and may require different lubricants and different viscosities. In the case of smaller units, splash lubrication may be used to lubricate both crankcase and cylinders from a single reservoir. • In the crankcase, the oil is lubricating primarily the plain bearings of the connecting rod where it attaches to the crankshaft and crosshead. — Oil is splash lubricated via the crankcase reservoir. — Depending on the temperature of the oil and frequency of oil change-out, lubricants can range from mineral oils to synthetic. • In the cylinders, lubricant is often dispensed by "force feed" at preset intervals to lubricate the sliding action between the piston and cylinder walls. — Due to the high temperatures involved and thin-film lubrication, cylinder lubrication should be done with a semi-synthetic oil containing ester (Castrol Tribol CS 1750) or, preferably, a full synthetic ester (Tribol CS 890). Ester containing lubricants maintain high solubility and low deposit formation to keep cylinders clean running over the long-term. — Mineral oils and non-ester containing synthetics can leave significant levels of carbon residue on the cylinder walls and exhaust valves, creating problems and high maintenance requirements. Reciprocating compressors were once very popular. However, rotary screw compressors have surpassed them in popularity due to lower maintenance requirements and a more compact design. Figure 2. Two-stage reciprocating compressor. Cylinder Cylinder Crank- R80

