Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Compressors Types of Compressors Rotary Screw Compressors Rotary screw is the most common type of compressor installed today due to its high pressure capability (up to 400 psig for two-stage arrangements), low maintenance and relatively small footprint. It uses a rotary motion, positive displacement mechanism to compress air. The mechanism consists of two counter-rotating, intermeshed helical screw elements housed within a specially shaped chamber. As the mechanism rotates, the meshing and rotation of the two helical rotors produces a series of volume-reducing cavities. Gas is drawn in through an inlet port in the casing, captured in a cavity, compressed as the cavity reduces in volume and then discharged through an outlet port in the casing. Figure 3. Cut-away of a rotary screw compressor, showing the intermeshing screws that produce the compression. In oil-flooded rotary screw compressors, oil is injected into the compression cavities to aid sealing and provide a cooling sink for the gas charge. The oil is separated from the discharge stream, then cooled, filtered and reused. Bearings and timing gears are also lubricated by the compressor oil. Air discharge temperature tends to be quite high in rotary screw compressors (often >180˚F and up to 220˚F), which can cause rapid oxidation of the oil. For this reason, most OEMs require synthetic or semi-synthetic lubricants to provide longer drain intervals and prevent residue build-up. Premium mineral oils may be used, but will require frequent oil changes (every 500 – 2000 hours). Viscosity ranges from ISO 32 to ISO 68, with ISO 46 being the most common. In dry rotary screw compressors, the oil lubricates only the bearings and timing gears, so temperatures are lower and lubricant requirements are less stringent. High-quality mineral oils are acceptable for these compressors. Rotary Vane Compressors Rotary vane compressors are small and quiet, but typically generate only low pressures (~100 psig). They have a rotor comprised of radial slots with a number of vanes inserted in the slots (Figure 4). The rotor is placed off-center to its housing. The vanes move in and out of the slots, maintaining contact with the housing. Upon rotation, the gas is pulled in via the inlet port, where the vanes are at maximum extension. As the vanes are forced into the slot via the housing (due to the off-center rotor), the volume of space reduces, thus increasing the gas pressure. When this pressure reaches its maximum, the gas is discharged to the system. In rotary vane compressors, the primary lubrication point is the tip of the vanes along the housing; however, bearings and rings also require proper lubrication. Viscosity choices can range from ISO 32 to 150, but typically are in the higher range of ISO 100 to 150. Anti-wear additives are required due to the high sliding friction between the vane and housing. High temperatures are encountered in these compressors, so semi-synthetic or synthetic oils are generally required. Figure 4. Rotary Vane Compressor. Image courtesy of www.about-air- compressors.com. Air Out Air In R81

