Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Compressors Compressor Oils Compressor Application Lubricated Parts Temp Level Typical Oils* Viscosity Range Reciprocating – Crankcase Plain bearings Moderate Mineral, Semi-Synthetic, Ester ISO 68-150 Reciprocating – Cylinders Cylinders, pistons High Ester-based (full or semi synthetic) ISO 100-150 Rotary Screw, flooded Screws, bearings, gears High Mineral (infrequent), Semi-synthetic, PAO, Ester, PAG ISO 32-68 Rotary Screw, dry Bearings, gears Low to moderate Mineral, Semi-synthetic ISO 32-68 Rotary Vane Vanes, housing, bearings High Mineral (infrequent), Semi-synthetic, PAO, Ester, PAG ISO 32-150 Centrifugal Bearings, gears Low to moderate Mineral, Semi-synthetic ISO 32 Figure 6. Summary of compressor applications and recommended lubricant types. *Mineral oil assumes the use of a premium oil with good oxidation resistance such as Castrol Hyspin VG (high quality turbine oil) or Tribol HM 943 (high performance AW oil). Semi-synthetic includes Castrol Tribol CS 1750. Ester includes Castrol Tribol CS 890. PAO includes Castrol Aircol SR. Compressor Cleaning and Oil Conversion Compressors are very sensitive to contamination. Contaminant build-up will cause higher operation temperature, premature oil degradation, compressor wear and failure. • Compressors that contain a minimal to moderate level of build-up may be successfully cleaned by using a detergent cleaner such as Castrol Techniclean SC 320. — Techniclean SC 320 will break up varnish, carbon deposits and sludge throughout the system. The product was designed to dissolve sludge and residue into very fine particles and keep them in suspension. — Normally, it is recommended to add the cleaner 48 to 72 hours prior to an oil change. Unless properly filtered, the presence of a detergent cleaner in the system for over 72 hours may cause excessive wear due to the high concentration of suspended particles in the oil. Specific cleaning procedure is outlined below. • Compressors with heavy build-up may be cleaned by using a synthetic ester compressor oil such as Castrol Tribol CS 890. — This fluid can be used on its own or added at 10% to the existing oil and run for 48 to 72 hours. — For systems prone to build-up, complete change- over to an ester-containing oil (e.g., Tribol CS 890 full synthetic or Tribol CS 1750 semi-synthetic) is recommended to maintain the compressor in clean running condition. R84

