Issue link: http://read.dmtmag.com/i/814629
Technical Training and Reference Info Lubrication Technical Training 1 800 255 4417 www.castrol.com/GPS March 2017 Fundamentals of Lubrication Tribology and Friction Fluid Friction Fluid friction is the resistance created within the fluid film when the molecules collide or rub against each other. It generally occurs when too much lubricant is present (i.e., over-lubrication) or the viscosity is too high for the conditions. A good example of potential fluid friction can be demonstrated by considering the lubrication of a bearing. Bearings are usually best lubricated by packing grease in about 30-50% of the available space within the housing. If the housing were to be packed 100% full, the grease would have "no place to go" as the rollers move through it, thus creating fluid friction within the grease. Dry friction is typically much higher than fluid friction, but fluid friction should not be overlooked as it can lead to heat, viscosity loss and increased wear rates. Sliding Friction Sliding friction is the force that resists sliding motion. Applications with sliding friction include slideways, screw threads, compressors, chains, hydraulic pumps, hydraulic valves, hydraulic cylinders, plain journal bearings, worm gears (high sliding), hypoid gears (high sliding) and other gear types (low to moderate sliding). As shown in Figure 5, the applied force must be greater than the frictional force for the block to move. Lubrication is designed to reduce this frictional force, which in turn reduces the applied force (energy) needed to perform work (move the block). applied force frictional force Figure 5. The mechanism of sliding friction. The applied force must be greater than the frictional force for motion to occur. Coefficient of static friction in sliding applications is determined by the force required to move an object divided by the weight of the object (Figure 6). This unit-less measure will vary depending on the types of materials in contact (Figure 7) and the degree of lubrication (if any) present. One of the goals of lubrication is to reduce the friction and thus the applied force needed to perform work. Force (F) Coefficient of friction (μ) F W = Weight (F) Figure 6. Coefficient of static friction as related to the applied force and weight of the object. Figure 7. Coefficient of dry friction of some commonly used materials in contact with each other. Materials in Contact Coefficient of friction (µ) Bronze on Bronze 0.20 Hard steel on Hard steel 0.42 Mild steel on Mild steel 0.57 Hard steel on Babbitt 0.34 Mild steel on Bronze 0.34 Sliding wear particles are a unique shape that can be identified under microscopic examination (Figure 8). This can be helpful in troubleshooting activities to identify the area of highest wear. Figure 8. Sliding wear particles. Side View Top Down View R3

